How do you take the pins out of a Ford door hinge?
Place the tip of the punch against the bottom tip of the bottom hinge pin (the tip is pointing down). Strike the punch with the hammer with enough force so the bottom hinge pin is dislodged from its location, but not so much so that the Ford F-150’s hinge or door sustains any damage.
Can you remove door hinge pins?
A-To remove the hinge pins, you use a hammer and a large screwdriver. Press the blade of the screwdriver under the edge of the pin head at a sharp upward angle, then tap with the hammer to drive the hinge pin up.
How do I get my pin out of emtek hinge?
2) The hinge pin is removed by tapping or pressing a punch or similar tool in the small hole at one end of the hinge. Once the pin is removed the hinge will separate into two pieces.
How do you remove tamper proof door hinges?
The procedure for removing the hinge pins is typical to all Emtek steel hinge types.
- Remove the hinge’s threaded pin security plug at the bottom of each hinge pin space, using a 3/32 inch Allen wrench.
- Tap upward on the bottom end of the hinge pin with a nailset or awl and a hammer.
What are part numbers for Ford door hinge pins?
It would be interesting if someone with a 94-97 car could verify. If you would rather use Ford bushings and hinge pins, those part numbers are D9ZZ-6643030-AA for the pins and D9OZ-6522841-C for the bushings. Again, I recommend the Dorman kit instead.
How do you replace hinges on a door?
Replace the pins. Once the door is in relative alignment with the hinges, it’s time to get the pins in. Take them out and lightly tap them in until the pin is at least slightly intersecting with the hinge and door. To help alleviate the gravity concerns, you should start with the top pin, then the bottom.
Where can I buy Ford L9000 door parts?
DOOR – PASSENGER SIDE MANUAL – METAL ROUND PUSH BUTTON Make: FORD Model: L9000 DOOR PARTS ONLY – PASSENGER SIDE – MANUAL – CALL FOR PRICING Make: FORD Model: L9000 DOOR PARTS ONLY – DRIVER SIDE – MANUAL – CALL FOR PRICING Make: FORD Model: L9000 NEW – AFTER MARKET – MANUFACTURED BY NORTHEAST – RIGHT HAND SIDE – PADDLE HANDLE – DOOR SHELL -…
What to do when you need to remove a pin from a door?
Sliding books underneath the crack in the door will give the door a surface to sit on while you remove the pins. If you have another set of hand ready, the second person can serve this purpose by holding the door steady while you tend to the following step. Force the pin up from the door hinge.