How to reset the oil light on a GMC Yukon?
GMC Yukon Change Engine Oil Light Reset Procedures: 2003-2015. Turn ignition switch to ON position with engine off. Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key. Change Oil lamp will flash for 2-10 seconds while it resets.
How to reset service engine light on GMC Envoy?
Place the key in the ignition and turn the key two clicks forward to the accessory power position. This will illuminate the lights on the instrument panel without starting the engine of the Envoy.
How to reset the service engine soon light on GMC cars?
How to Reset the “Service Engine Soon” Light on a 1998 GMC. Open the hood of the GMC and loosen the retaining nut on the negative battery cable clamp. Slide the cable clamp off the negative battery terminal. Wait 15 minutes, then reconnect the cable clamp.
How to reset the change engine oil light?
GMC Yukon Change Engine Oil Light Reset Procedures: 1 Display the “Oil Life Remaining” message in the Driver Information Center 2 Press and hold the SET/RESET button on the Driver Information Center for more than 5 seconds (on vehicles without DIC, use the TRIP reset stem for SET/RESET) 3 The oil life will change to “100%”
When to reset oil service light on GMC Yukon?
Steps by step tutorial on how to reset the oil service maintenance reminder indicator message light on GMC Yukon from the year 2007-2008-2009-2010-2011-2012-2013-2014-2015-2016-2017-2018-2019-2020. Close all doors, gear to park position.
How do I reset the Check Engine light?
One way is by disconnecting the battery cable for 2 to 3 minutes and waiting to see if the check engine light comes back on upon reconnecting the battery and start the car.
How to reset a change engine oil light on a 2002 GMC?
Press the gas pedal three times within five seconds. Wait for the oil light on your dash to blink for five seconds and then shut off. The “change engine oil” light has now been reset. “Chevrolet Express, GMC Savana Full-Size Van Repair Manual 1998-2007”; Mike Stubblefield; 2008
How to Reset the “Service Engine Soon” Light on a 1998 GMC. Open the hood of the GMC and loosen the retaining nut on the negative battery cable clamp. Slide the cable clamp off the negative battery terminal. Wait 15 minutes, then reconnect the cable clamp.