Is there a DTC for a GM 4WD?
Some later model 4WD systems have scan tool capabilities along with diagnostic trouble codes (DTCs) to help locate and diagnose many of the problems associated with them. We looked at two GM K 1500 trucks that have the NVG 246 two- speed transfer case. One is a 1999 model, the other a 2000.
What kind of transmission does a Chevy NV4500 have?
According to Motivegear.com, the NV4500 has a cast-iron casing with an aluminum shift cover on top. The bell housing is not integral to the transmission and warning labels may be attached to the transmission specifying the use of Castrol Syntec fluid only. The NV3500 is an all-aluminum casting with the bell housing integral to the transmission.
What is the GM 4 wheel drive Bulletin?
GM has issued a service bulletin # 09-04-21-001 to address a Service 4 Wheel Drive Message condition on the vehicles listed below. In addition to the Service 4 Wheel Drive Message, you may also have a C0387 or a C0569 trouble code stored. 2007–2009 Chevrolet Avalanche, Silverado, Silverado Hybrid, Suburban, Tahoe, Tahoe Hybrid
What kind of transmissions did Chevy trucks have in 1994?
A variety of transmissions were used on 1994 Chevrolet trucks. The transmissions included automatic models 4L60 and 4L80, the Borg Warner T5 manual and New Venture manual models 3500 and 4500.
Some later model 4WD systems have scan tool capabilities along with diagnostic trouble codes (DTCs) to help locate and diagnose many of the problems associated with them. We looked at two GM K 1500 trucks that have the NVG 246 two- speed transfer case. One is a 1999 model, the other a 2000.
How is the transmission on a Chevy Silverado controlled?
The transmission in your truck is controlled by the PCM (powertrain control module). It is sophisticated enough to be able to tell you if there is an issue with your transmission. The local auto supply may be able to scan it, but it may take a better scanner to dive deeper into the PCM.
What does DTCs stand for in GM transfer case?
DTCs will stay in memory for 100 key cycles. The dash buttons to the right of the air vent identify this system as an NVG 246 automatic two-speed, which means it has DTCs and scan tool capabilities. mode control is a set of normally open switches that vary the voltage supplied by the transfer case module when closed.
Where is the encoder motor on a GM transfer case?
Access to datastream information for GM’s NVG 246 system makes most problems simple to locate and diagnose, as our case studies demonstrate. These systems also allow bidirectional control for many outputs. The encoder motor (arrow) is mounted on the front of the transfer case and is used to lock it into 4WD.