How do you adjust the valves on a 3126 Cat?
Then, turn the adjustment screw in a clockwise direction. Slide the feeler gauge between the rocker arm and the valve bridge. Continue turning the adjustment screw until a slight drag is felt on the feeler gauge. Remove the feeler gauge….
| Valve Lash | |
|---|---|
| Valves | Dimension of Gauge |
| Exhaust | 0.64 ± 0.08 mm (0.025 ± 0.003 inch) |
How do you adjust a 3116 valve?
Place the appropriate feeler gauge between rocker arm and the valve bridge. Then, turn the adjustment screw in a clockwise direction. Slide the feeler gauge between the rocker arm and the valve bridge. Continue turning the adjustment screw until a slight drag is felt on the feeler gauge.
How do you adjust the valves on a 3208 Cat?
3208 – Valve Lash Setting
- Remove the valve covers.
- Turn the crankshaft Counterclockwise (as seen from rear of engine) until No.
- Make adjustment to the valves for No.
- After the adjustment is complete, hold adjustment screw (1) and tighten locknut (2) to 32 ± 7 N·m (24 ± 5 lb ft).
How to adjust # 3 intake valve exhaust valve?
Adjust #3 Intake Valve Exhaust Valve Adjustment: ENGINE OFF! You will notice that this is the same procedure and sequence as the intake valves listed above. Only now you are adjusting ONLY the exhaust valves the same way. with #1 cylinder Exhaust Valve at full valve lift …. Adjust #6 Exhaust Valve
What are the valve actuators on a cat C15 Acert?
Refer to Specifications, “Variable Valve Actuators” for the proper torque for the jam nut. Turn the crankshaft clockwise by 360 degrees. This will position the No. 6 piston at the top center on the compression stroke.
How to adjust unit injectors on Cat MXS?
Turn unit injector adjustment screw (2) clockwise until the correct height is obtained. Hold the adjustment screw in this position and tighten locknut (3) to a torque of 100 ± 10 N·m (74 ± 7 lb ft). To make an adjustment to the unit injectors on cylinders 1, 2, and 4, remove the timing bolt.
How do you adjust exhaust valve on C-15 ACERT?
Loosen the locknuts on the three jakes that match the exhaust valves. Insert the allen wrench, and back all six pistons off 1/2 of a turn. This will ensure that they are not touching the 3 intake & 3 exhaust valves you are about to adjust.