How do you remove universal joints from a car?

How do you remove universal joints from a car?

Remove the bolts at the rear of the driveshaft. The driveshaft connects to the car with 4 bolts on its rear. Use a socket wrench to unscrew each bolt by turning them counterclockwise. Keep the bolts in a safe place so you can reinstall them later.

How do you remove an you joint from a hard drive?

Three common methods are used to remove the pressed-in, u-joint bearing cups from the driveshaft. One method requires a u-joint removal tool which is rather expensive unless you will be using it repeatedly as a professional technician.

What’s the best way to replace a U-joint?

There are two accepted ways to replace U-joints: with a hammer and with a specialized tool. You can see the rust on this U-joint, which caused joint failure. This occurs when the joints are lubricated regularly. Source | Mike Aguilar

How do you remove you joint bearing cups?

Three common methods are used to remove the pressed-in, u-joint bearing cups from the driveshaft. One method requires a u-joint removal tool which is rather expensive unless you will be using it repeatedly as a professional technician. Another method requires using a big hammer and hitting things hard.

How do you change u – joints?

Press the U joint out one side of the shaft. Remove the bearing cap and then press the joint and bearing cap out the other side. Handle the driveshaft carefully while doing this. Stop to compare the old part and new part. Then, reinstall new joints by removing the bearing caps and needle bearings.

How do you replace you joints?

How to Replace a U-Joint ( Universal Joint ) Securely jack/hoist the car. Place a hand on each side side of the u-joint, not the u-joint itself, but the drive shaft or yoke it’s connecting. Try to rotate your hands in opposite directions. If there is play in the joint, it needs replaced.

What are the types of universal joints?

  • Hooke. The Hooke style universal joint is perhaps the most widely known joint in the United States.
  • Ring and Trunnion. The ring and trunnion universal joint is designed with a female and a male rod at either end of the center cross point.
  • Bendix-Weiss. Bendix-Weiss is a universal ball joint that has a hollow center containing four small metal balls.