What are the two wires in a two pin plug?
The two pins at the bottom which are placed parallel to each other are the live wire and the neutral wire respectively. The live wire is on the left-hand side while the neutral wire is on the right-hand side.
What Colour wires are in a plug?
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN and YELLOW.
What should be done to connect the wires in the plug correctly?
The wires. In a plug, the blue neutral wire goes to the left, the brown live wire to the right and the green and yellow striped earth wire to the top. The fuse fits next to the live wire.
Can you wire a plug without earth?
Earthing. Without the earth wire, if a fault occurs and the live wire becomes loose, there is a danger that it will touch the case. The next person who uses the appliance could get electrocuted . As a result, the casing cannot give an electric shock, even if the wires inside become loose.
What is the advantage of a 3 pin plug over a 2 pin plug?
3-pin plugs also limit the amount of power that can flow through the circuit, as compared to a 2-pin plug. Hence 3-pin plugs are safer as compared to 2-pin plugs.
Where do you put the connector identifier on a wire?
A connector identifier is placed next to the arrows to indicate the con nector number (Fig. 4). For viewing connector pin outs, with two ter minals or greater, refer to section 8W -80. This section identifies the connector by number and provides terminal numbe ring, circuit identification, wire colors and functions.
What is the wiring diagram for a fuel pump?
Automotive Diagnostic Spe… heat indicator wiring diagram from sending unit to guages. original engine was 305. Previous owner (s) switched to 350. guage does not … read more
Where is the glow plug control module located?
Located on the engine and with a direct connection to the engine control unit, the control module uses a microprocessor to analyse input from the engine control unit to determine information related to the working of the glow plugs.