What causes a Detroit Diesel Series 60 to spin?
If there’s an issue with your throttle, that’s a good place to start. Bearing problems, particularly spun bearings, are typically caused on older Series 60 by low oil pressure at idle. A spun bearing occurs when there is a lack of lubrication causing overheating. The bearing can eventually seize, creating even more problems.
Are there any problems with the Detroit Series 60?
This issue did not affect all pre-2002 Series 60 engines, but it was a problem that occurred and could cause catastrophic engine failure. As with most engines, it’s a good idea to keep an eye on your cooling system. Overheating is the cause of many major issues with diesel engines, so maintaining this system can help with many preventable issues.
Why are my Detroit Diesel Series 60 brakes not working?
These brakes could require different programming than what is standard on the Series 60, and the disconnect could cause a loss of throttle. If this is not the issue and you’re still experiencing throttle issues, you’ll probably want to take a look at your TPS (throttle position sensor).
What to do if your Series 60 engine is not working?
If this is not the issue and you’re still experiencing throttle issues, you’ll probably want to take a look at your TPS (throttle position sensor). This sensor works with the electronic control system in drive-by-wire applications like the Series 60 engines, allowing for the electronic control to occur.
Is there a power loss on a Detroit 60 series?
I have a power loss… I have a power loss on a Detroit 60 series engine its in a freightliner classic 2003.
What causes a series 60 engine to fail?
This separation allowed the connecting rod to disconnect as well, and one of the loose components would then damage the engine block, often by creating a hole through it. This issue did not affect all pre-2002 Series 60 engines, but it was a problem that occurred and could cause catastrophic engine failure.
What should the PSI be on a Detroit 60 series engine?
1200-1300, you should have 30-45 psi 1800-2100, you should have 65-80 psi If the fuel pressure is high, I would suspect a plugged fuel filters or faulty fuel pressure regulator. If the guage is really bouncy, and unstable, especially under boost, then compression could be leaking past the injector o-rings.
Are there any problems with the Detroit Diesel 14L?
Another common complaint, especially with the 14L, is poor fuel economy. As the engine got bigger and was designed for more horsepower, fuel usage seemed to increase as well. Some argue that this lowering of fuel economy is not due to engine design, but to poor operating practices.
Are there any problems with the series 60 engine?
We’ve briefly discussed some of these problems in our Series 60 spotlight, but we’ll dive into them a bit more fully here. It Still Runs also mentions a few of these issues. Cold starts, aptly named for starting your engine in cold temperatures, have given Series 60 engines trouble. They can lose their prime and not start properly.