What causes no power to the rear right window of a 2000 Oldsmobile Intrigue?

What causes no power to the rear right window of a 2000 Oldsmobile Intrigue?

What would cause no power to the rear right window of a 2000 Oldsmobile Intrigue? GMC power window troubleshooting for this problem will require a voltmeter. On the switch for this window, check for battery voltage at the purple and light green wires. If there is power, then check the dark blue wires at pin B of the window switch for voltage.

What causes one power window to stop working?

Only one window stops working If only one window stops working, the problem could be a bad relay, fuse issue, bad motor, or the power window switch has failed. The most common reason for one window to stop working is the switch, so this should be looked at by a professional mechanic to have your power window switch replaced.

Why is my car window not rolling up?

For electric-powered windows, check the fuse and wiring circuit to the motor, including the operation switch. Any of the points in the electrical system can fail, and prevent the window from moving. The battery might be dead, or the car’s ignition may not be turned on, as some cars require for window operation.

Why are the windows on my Chevy Silverado not working?

The driver side and right rear window worked fine. Both right side windows would go up but not down. After checking and surching for 8 hour, I finally check diver side master switches, took the switch apart, found it had sand in it from a trip we had made to the beach.

What makes a car window not roll up?

Car windows are typically a sheet of glass set into a scissor-pulley track, turned by a crank that is either hand-operated or motorized. When the glass does not roll up and close, several parts may have malfunctioned and require repair.

Only one window stops working If only one window stops working, the problem could be a bad relay, fuse issue, bad motor, or the power window switch has failed. The most common reason for one window to stop working is the switch, so this should be looked at by a professional mechanic to have your power window switch replaced.

Are there any problems with the power window on a Silverado?

Re: Driver Side Power Window problems. So has anybody figured out the mysterious 2007 Silverado drivers door window issue?

Why does my GMC Sierra SLE stop working?

1999 GMC Sierra SLE Extended 4×4 – Replaced Regulator & Motor because window jumps when pressing button but does not move window. Still having the same problem.

How many wires does a power window motor have?

Second: Power window motors only have two wires. When you operate the down cycle on your power window switch, it provides + power and – ground to the power window motor. When you operate the up cycle, the switch reverses the polarity on those same two wires.

What causes a power window regulator to fail?

If your driver’s window is making bad noises or not going up and down properly this most likely is your problem. W116 driver power window failure is very common. It happened to Kent’s personal 1979 300SD. Brand new passenger front power window regulator. Motor not included Fits the following 126 models: Currently out of stock.

Why is my Mercedes Benz power window not working?

This problem is starting to show up more often as all these old Mercedes Benz age. If you have replaced other parts and are still having problems with the operation of one of your power windows, then you might want to check this, especially if the window is showing signs of intermittent operation.

What causes the motor to rotate and lower the power window?

Direct current flow in this position causes the motor to rotate and lower the power window. Back probing the connector will show 12 volts between the two wires and -12 volts if we reverse our test leads. To raise the power window, we push the switch in the opposite direction. This reverses the polarity of current flow within the switch.

Second: Power window motors only have two wires. When you operate the down cycle on your power window switch, it provides + power and – ground to the power window motor. When you operate the up cycle, the switch reverses the polarity on those same two wires.

Where are the power window switches located on a car?

The switches are located near each window, with a master panel on or near the driver’s door. Over time, the fuse, motor, or regulator can go bad and need to be replaced.

What causes a GMC power window to move?

The passenger side switch is the probable cause. The driver’s side switch uses the relays in the passenger switch to operate the window and if this is defective a good driver’s side switch will not cause the window to move. Replacing the passenger side switch should fix the problem.

Why is my crank window not working in my car?

This would never happen with a crank window system because it uses manual human power to open and close it. But still, it is not that big a deal because it will not impair your driving abilities.

Why is my passenger window not working but the driver window is working?

When passenger windows don’t work, but the driver’s window does, chances are high that you’ve got a bad master switch in the driver’s door or a broken wire in the driver’s door hinge area. Second: Power window motors only have two wires.

What would cause no power to the rear right window of a 2000 Oldsmobile Intrigue? GMC power window troubleshooting for this problem will require a voltmeter. On the switch for this window, check for battery voltage at the purple and light green wires. If there is power, then check the dark blue wires at pin B of the window switch for voltage.

What should I do if my GMC power window is not working?

If there is power, then check the dark blue wires at pin B of the window switch for voltage. If no voltage is detected on any or some of the wires, the wiring in the door jamb should be wiggled while the voltage is monitored to see if the is a fluctuation. If there is, it indicates broken or loose connections in the door jamb.

This would never happen with a crank window system because it uses manual human power to open and close it. But still, it is not that big a deal because it will not impair your driving abilities.

What to do if your passenger side window is not working?

If it’s the passenger window that is malfunctioning, you can test the switch by using the driver side window controls. If it works using those controls, you will need to replace that window switch. If it’s the driver side window that’s not working, you’ll need to swap out the controls to test it.

Why does my back window not roll down?

The wiper is electrically inline with the window relay. If it is not all the way up (sagging) then your window will not roll down. Hope this helps. Also, the relay board that operate rear window defog, and up/down is located drivers side behind the front seat behind the plastic trim. 127 people found this helpful. 13 people found this helpful.

Why are the back windows on my Ford F350 not working?

My back windows wont work. Ive replaced the back window motors and the control switch on the drivers door and still nothing. any ideas? Clicking this will make more experts see the question and we will remind you when it gets answered. You can’t post conmments that contain an email address.

What causes a power window to not go down?

There are a number of things that could be causing a malfunction of your power window. First off, is it only one window that won’t go down? If so, it might be a single connection, switch, or motor that’s not working. If all power windows aren’t working, then it might be a fuse or relay.

Why are my Silverado windows not going down?

I purchased a 1991 Silverado for my son and the windows worked fine for a month and then they started to stop and go at times. I replaced the switches and checked the relay and all were fine. I then took the panel apart and it looks like the previous owner made speaker holes in them and damaged some of the wires in the process.

What should I do if my auto window is not working?

Roll the windows up and down a couple of times using the auto function to ensure everything is working properly. Performing these steps should restore your auto window function. If it does not, there may be further problems with the system.