What does ALt mean on a Thermo King APU?
ALt: This code indicates that a charging system failure has occurred. This code will occur if there is no alternator output after 2 minutes of operation. To clear Alarm Codes, use the HMI Main Power Key to turn off the TriPac system.
What is a Thermo King TriPac?
The Thermo King TriPac Evolution APU (Auxiliary Power Unit) provides auxiliary heating, cooling temperature management that allows drivers to reduce unnecessary truck engine idling, conserve diesel fuel and save money. A fuel-fired air heater provides sleeper compartment heat in cold conditions.
What is code 63 on a Thermo King?
This error code indicates your Thermo King has a low engine oil level. To fix this issue, you need to refill your engine with oil. In case you recently filled your engine with oil, check the oil level sensor. Before deciding to replace the oil level sensor, disconnect and clean the sensor first.
Where is the reset button on a Thermo King APU?
The newer Evolution model does not have that button, resets are done by turning the unit off and on at the control panel. The unit will not start if the switch on the actual TriPac engine is in the off position, which you will have to open the panel like you are checking the oil to see.
When to turn off the TriPac Apu alarm?
This code will occur if there is no alternator output after 2 minutes of operation. To clear Alarm Codes, use the HMI Main Power Key to turn off the TriPac system. This is straight from the Manual and these are ALL the codes (except the “In my own words” part). A lot of people are trying to find these codes so here they are!
What does the Thermo King TriPac Apu do?
Reduce idling and increase driver comfort with Thermo King’s TriPac ® APUs, available in diesel or electric models. Drivers spend long days away from home on the road, and a comfortable sleeper is important for well-rested and safe drivers. The TriPac Evolution brings the comforts of home to wherever home is for the night.
What does the Eng code on the TriPac controller mean?
TriPac HMI Controller alarm codes are: EnG: This code indicates that the “8” circuit has a failure. This can be caused by an open engine reset switch (resulting from low oil pressure or high water temperature) or the Main Power On/Off Switch is in the off position.
Is the TriPac evolution an auxiliary power unit?
The TriPac Evolution brings the comforts of home to wherever home is for the night. A clean, reliable all-electric auxiliary power unit (APU) that not only saves fuel but delivers unmatched driver comfort previously unavailable in an electric unit.