What fluid does a AX5 transmission take?
Yes, 10/30 motor oil is approved to use and easiest to get, and most economical, a win, win, win. X 2. Of course Synchromesh is approved for use in both the AX-5 and 15 trannys. It is MADE for use in manual transmissions with soft metal (read: brass) synchros.
What type of transmission fluid does a jeep take?
FRAM Chrysler ATF+4 fluid is recommended for use in all transmissions, hydraulic systems, and power steering units manufactured by American, European, Korean, Japanese and other manufactures from around the world specifying Chrysler ATF+4, ATF+3 or ATF+2 Type Fluids.
How much fluid goes in an AX5 transmission?
$8.88/dt at advance auto. it takes 2.9 quarts… i dropped in 3. I am running Redline Mt90 here and I love it.
What’s the best transmission fluid for Jeep Wrangler?
Max ATF® is recommended for all automatic transmissions on 1966-2021 Jeep CJ and Wrangler models requiring Mopar transmission fluids. Four (24) quarts are required for regular transmission maintenance; Eight (8) quarts for a full overhaul or dry fill.
What is GL3 gear oil?
GL3 is the next level of performance and has very limited applications. Mainly specified for French and Italian (Fiat & Alfa) cars which had very soft synchromesh. It has very low EP (extreme pressure) performance and does not contain the concentration additives used in later engines.
How does a synchromesh unit work?
The synchromesh has an inner spline that coincides with the output shaft and then an outer spline that allows an inner ring to move internally within the gear. This outer ring is designed to only mesh with the bulk ring once their speeds are matched, meshing the teeth together.
What type of transmission fluid goes in a 2000 Jeep Grand Cherokee?
O’Reilly Conventional Transmission Fluid Dexron III/Mercon 1 Quart.
What fluid does a np231 transfer case take?
All Wrangler transfer cases require ATF, literally any ATF is fine with ATF+4 being a superb choice. It holds about 2 quarts.
Where does transmission fluid go Jeep Wrangler?
On models with a dipstick, it will be near the firewall on the driver’s side. On models without a dipstick, remove this cap from the filler tube and check the fluid level with tool no. 9336A or equivalent.
What is 80W90 gear oil used for?
Application. Gear Oil 80W-90 is designed for use in differentials, both hypoid and limited slip, manual gearboxes, transfer cases and transaxles in passenger cars, light commercials, 4WDs, trucks, construction, earthmoving and agricultural equipment, where this viscosity grade is required.
What kind of transmission does a jeep AX5 have?
The case is ribbed and features the shifter in the rear quarter of the assembly. In the vein of newer transmissions, the AX5 uses dowel pins for bellhousing alignment. The Jeep AX5 has a 21 spline output shaft for connecting to the transfer case input shaft. The AX5 was used with an internal slave/throwout assembly up through the 1994 model year.
What kind of lubricant should I use on my AX15 transmission?
I have found some conflicting information concerning the use of certain gear lubricants in the AX15 transmission. The factory service manual recommends 75w90 GL-3. The dealer only supplies synthetic gear & axle lubricant 75W90 GL-5.
What kind of fluid does a Jeep Wrangler use?
Jeep Wrangler JK Fluid Capacities Component Quantity Fluid Type Clutch Fluid Fill to Full Mark DOT 3 Power Steering Reservoir Fill to Full Mark ATF 4 3.8L Cooling System 13 Quarts 50/50 Antifreeze/Water Mix 3.6L Cooling System (2013-2018) 10.5 Quarts 50/50 Antifreeze/Water Mix
What kind of transmission does a Jeep XJ have?
Aisin-Warner AX5 Transmission. The Aisin Warner AX5 transmission was a standard shift, five-speed transmission introduced in the 1984 XJ Cherokee Jeep, and found in the 1984 to 2006 Jeep XJ, YJ, and TJ models. It is a light-duty transmission found behind the AMC 150 (2.5L) I4 engine.