What happens when your car is idling at 500 RPMs?
When my car is idling it is at 600 RPMs but it drops to 500 and starts shaking like its going to shut off. What is my problem ? My car has 116000 miles.
Is the warrior Idles fine when trying to accelerate?
The warrior idles fine. I’ve adjusted to air mix screw back and forth. It changes the idol but doesn’t seem to improve things when I try to rev it up. 2.25 turns seems to be the sweet spot, as far as idol. The needle is where zoom put it.
What to do if your bike Idles when trying to accelerate?
Clean the carb,run some sea foam through it,if that doesn’t work,try your timing.if all else fails it could be a sticky valve and or a bent valve ( I ran a bike on a bent valve for 2 months before it blew) How do you check the valves. I’m not a mechanic but I can do the small stuff. Lol I have a 89 warrior. I put it in the shed during deer season.
Why does my Raptor idle when trying to accelerate?
Sounds like the accelerator pump isn’t working, or pilot is partially plugged, or air mixture is too lean. May be a combo of several of those things. When my sons Raptor was doing that, it was because the pilot was too small, then had to tweak the air mixture to get it just right.
When my car is idling it is at 600 RPMs but it drops to 500 and starts shaking like its going to shut off. What is my problem ? My car has 116000 miles.
How can I tell if my idle control valve is working?
To check if an idle control valve is working properly, start by turning on your engine and letting it run for a minute or 2. Then, when it’s at an idling speed, take note of the RPMs in your car. Next, turn the engine off and disconnect the idle control motor under your hood.
What does it mean when your engine idle is too low?
If your idle is too low, it could be the IAC not talking to the computer correctly. Disconnect the IAC connector for a couple seconds while your engine is idling. If your engine idle didn’t change, you can suspect it to be the IAC. If it is working properly, unplugging it would cause your idle to freak out.
What happens when the idle control motor is disconnected?
With the Idle Control Motor disconnected, get back into the vehicle and start the engine again. The engine should still start and run without any issue despite the idle control motor being disconnected. Be sure to tuck the wiring you disconnected up in the engine bay so it doesn’t get caught in any moving parts.