What kind of ODS inspection can I do on my car?
There are three different ODS seat weight sensor inspections that can be done using the HDS: This inspection checks only the empty front passenger seat’s weight as a “quick check” of the existing seat weight sensor’s calibration.
How to troubleshoot SRS occupant detection system ( ODS )?
Move the seat to its rear-most position. Adjust seat height to its lowest position. Lean the seat-back to its most upright position (seat-back straight up with zero recline). Drive the vehicle at 22 mph (36 km/h), then park the vehicle on level ground. Turn off the engine and HVAC system.
When does ODS and SWS need to be recalibrated?
Requires initialization when the seat cover, the seat back/OPDS sensor, or the ODS/OPDS unit is replaced. Requires recalibration (SWS Initialization) when seat weight sensors or the ODS/SWS unit is replaced. When seat weight sensors were first added, there was a separate SWS unit mounted under the front passenger’s seat.
What should I do if my ODS unit is replaced?
ODS unit replaced. The occupant detection system (ODS) or occupant position detection system (OPDS) may not initialize if there are SRS DTCs or an SRS unit problem. The scan tool is the preferred method for initialization because it has the ability to confirm proper completion.
How does the oxygen depletion Sensor ( ODS ) work?
The Oxygen Detection Safety-Pilot, or Oxygen Depletion Sensor (ODS), ensures that air levels are safe in your home. This device works by detecting the level of oxygen in the room of your vent-free unit.
Move the seat to its rear-most position. Adjust seat height to its lowest position. Lean the seat-back to its most upright position (seat-back straight up with zero recline). Drive the vehicle at 22 mph (36 km/h), then park the vehicle on level ground. Turn off the engine and HVAC system.
There are three different ODS seat weight sensor inspections that can be done using the HDS: This inspection checks only the empty front passenger seat’s weight as a “quick check” of the existing seat weight sensor’s calibration.
Requires initialization when the seat cover, the seat back/OPDS sensor, or the ODS/OPDS unit is replaced. Requires recalibration (SWS Initialization) when seat weight sensors or the ODS/SWS unit is replaced. When seat weight sensors were first added, there was a separate SWS unit mounted under the front passenger’s seat.