When to disengage the PTO on a truck?
READ AND UNDERSTAND ENTIRE MANUAL BEFORE INSTALLATION OR OPERATION OF PTO AND DRIVEN EQUIPMENT ALWAYS DISENGAGE THE PTO WHEN THE DRIVEN EQUIPMENT IS NOT IN OPERATION. DO NOT ATTEMPT TO INSTALL OR SERVICE ANY POWER TAKE-OFF WITH THE TRUCK ENGINE RUNNING. PUT THE IGNITION KEYS IN YOUR POCKET BEFORE GETTING UNDER THE TRUCK.
What kind of PTO does a Ram 3500 have?
0 \/201\ PTO Operation The 3500/4500/5500 Ram Chassis Cab vehicle, when equipped with either the automatic Aisin 6spd or manual G-56 6spd transmissions, will allow for an aftermarket upfit with a transmiss ion driven PTO (power take off). The customer will have the ability to operate the PTO in either a stationary or mobile mode .
How many PTO speeds can I set in remote mode?
Remote PTO can be calibrated for one to three selectable engine speeds. Remote mode also is the only method that accommodates multiple PTO speeds. Up to three different PTO speeds can be programmed. These speeds are programmed via the Electronic Vehicle Information Center (EVIC) screen in the center of the cl uster (see page 2).
What should I know before installing a PTO?
OBTAIN PROPER TRAINING BEFORE OPERATING THIS MACHINERY DO NOT INSTALL OR OPERATE EQUIPMENT WHICH HAS NOT BEEN PROPERLY SPECIFIED FOR YOUR EQUIPMENT. ALLOW THE VEHICLE, PTO AND DRIVEN EQUIPMENT TO WARM UP WHEN OPERATING IN WEATHER WHERE TEMPERATURES ARE NEAR OR BELOW FREEZING 32º F (0º C).
Where can I get a new PTO for my truck?
WWW.SANDSTRUCK.COM• Customer Service Order Desk: 844.446.7388 Newstar stocks a variety of Replacement PTO & Hydraulic components including: PTOs, Dump Pumps, Hydraulic Pumps, Hydraulic Tanks, Conversion Kits & more.
Where is the PTO label on the visor?
It should be located near the PTO control, when the control is installed in the vehicle dash (See Figure 1.2). This label directs the operator to read the PTO operating instructions on the “Visor Label”. The Visor Label 4″ x 6½” is to be placed on the visor on the operator’s side of the vehicle (See Figure 1.2).
How does a PTO work on a 6 bolt truck?
1. Let engine idle. 2. Apply brakes, while seated in driver’s seat. 3. Place shift selector in any drive range. 4. Engage PTO. 5. Shift transmission to neutral or park. Power Shift PTOs Manual or Automatic Trans. 1. Let engine idle. 2. Engage PTO with switch. 3. Resume operating speed. NEVER GET UNDER THIS TRUCK IF THE ENGINE IS RUNNING!