Why does my seat belt light keep coming on?
Check the connector in front of the seat belt buckle. It may have been left disconnected when you had your upholtstry work done. You can use a jumper wire to jump across the connector or use an ohm meter across the terminals while clicking the seat belt in and out to check the buckle itself.
What happens when you leave your seat belt Unplugged?
This leads to the seat belt warning on the instrument cluster, as well as the buckle chime. By leaving the buckle unplugged you will NOT get the buckle chime or warning lamp upon turning the igniton on. If want that feature, you will have to figure out another way to do this.
What to do if your seat belt buckle goes out?
You can also tape the now-loose buckle end of the connector out of the way. • Reconnect the battery. • Use your code reader to reset the Airbag light. Turn the ignition on/off fully a few times to make sure the airbag system passes its test and the airbag light goes out. Take it for a test drive also.
Where is the seat belt warning light located?
As already mentioned, the seat belt warning system is an electrical circuit that is remaining open and triggering the warning. One common place where this circuit is broken is under the seat. Located under the drivers seat, or sometimes the passenger seat on certain vehicles is the airbag and SRS (supplemental restraint system) unit.
Why does my seat belt reminder light stay on?
My seat belt reminder light stays on and flashes despite the seatbelt (driver side) being buckled. Several months ago I – Answered by a verified Chevy Mechanic We use cookies to give you the best possible experience on our website.
What causes the seat belt light to stay on AF?
With the ABS light, this could be an indication of a damaged ABS module, individual wheel sensors or electrical harness failure. Having a professional mechanic complete a warning light inspection will help them diagnose the actual source of this problem and recommend the correct repairs. Was this answer helpful? Thank you for your feedback!
What happens if you dont put your seat belt on?
If you don’t fasten the seat belt and start driving, most vehicles will start flashing and chiming at you until the seat belt is secured. Sometimes, the seatbelt switch can get stuck or broken and the light won’t turn off. Clean out the buckle or replace it, if necessary, and everything should return to normal.
What to do if your seat belt alarm keeps dinging?
Blow it out with a portable can of air. Make sure both the male/female parts of belt are clean, non-rusted/corroded & non-damaged to make good electrical connection when belted in; this turns off your belt warning light and bell.