How do you reset the electronic throttle control system on a Jeep Wrangler?

How do you reset the electronic throttle control system on a Jeep Wrangler?

Turn ON your ignition without igniting your engine for about 2 seconds, then turn OFF the ignition for 10 seconds. Turn ON the ignition again for 2 seconds and turn it OFF for 10 seconds. This will notify your computer system of the new position of your gas pedal and closed position.

What is the ETC light on a Jeep?

Solution: This indicates a serious failure of your throttle control system. The engine computer is programmed to go into limp mode when the system malfunctions, in an attempt to limit your speed and prevent damage to the engine. It can be caused by a sensor failure, or even by outside electromagnetic interference.

What does ETC light mean?

Electronic Throttle Control Light Meaning When your vehicle’s electronic throttle control light turns on, it means that your car had detected a fault in the electronic throttle control system. The electronic throttle control system control and monitors the position of the throttle.

How much does it cost to fix a electronic throttle control?

Since this is such a key part to every car’s internal system, the average cost for this repair can be quite pricey – the average electronic throttle control repair cost comes out to around $645!

Is there a problem with the etc light on my Jeep?

Well, I think I may have finally fixed the electronic throttle control light problem on my Jeep. This has been a problem for the past several months. The ETC light would come on several times a week. The dealer replaced the throttle body and throttle position sensor, the powertrain control module, and the gas pedal assembly and sensor.

What is the throttle control warning light on 2016 Jeep Wrangler?

See all problems of the 2016 Jeep Wrangler . The contact owns a 2011 Jeep Wrangler. The contact stated that the electronic throttle control warning light illuminated on the instrument panel as the vehicle stalled. The vehicle was restarted but would not accelerate beyond 40 mph.

What kind of transmission does a Jeep Wrangler have?

The 42RLE is a medium duty overdrive, 4-speed, automatic transmission that lives in Wranglers born from 2003 to 2011. These transmissions feature four forward gears including one overdrive gear. With an aluminum housing, the NV1550 was a short-lived 5-speed manual transmission for Jeep Wranglers.

Are there any problems with the 2017 Jeep Wrangler?

See all problems of the 2017 Jeep Wrangler . Issues started with vehicle not able to start and inability to shift out of park. Battery would test good. After disconnecting battery, vehicle would start as usually. Issue began to escalate with oil light and esp light randomly lighting up on the dash.