How do you reset the oil light on a 2001 Honda Civic?

How do you reset the oil light on a 2001 Honda Civic?

Oil Change Light Reset Honda Civic 2001 Procedure

  1. Turn the ignition off.
  2. Press the “SELECT” and “RESET” switches at the same time, and turn to ignition to the “ON” position.
  3. Hold switches for at least 10 seconds until the indicator is reset.

How to reset maintenance oil service light Honda Civic?

How to reset maintenance oil service light Honda Civic. From years: 2001, 2002, 2003, 2004, 2005. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).. Hold the button for at least 10 seconds, until the indicator resets..

How do I reset the oil life monitor?

Follow the steps below to reset the oil life monitor after each oil change. Turn the ignition off. Press the “SELECT” and “RESET” switches at the same time, and turn to ignition to the “ON” position. Hold switches for at least 10 seconds until the indicator is reset. Turn the ignition off.

How much oil to put in Honda Civic?

Holding the funnel with one hand, use your other hand to pour in about 3.7 quarts of 5W-20 new motor oil. Eyeball it. It’s better to add too little at first because it’s always easier to add more rather than drain the extra oil. Once you’re done with that, screw back in the oil filler cap so that it’s a snug fit.

Where is the oil filter on a Honda Civic?

From the underside of the car, locate the oil filter. It will be installed on the engine block just above the driver side axle shaft. Keep the oil drain pan nearby as you reach up to get a grip on the oil filter. Loosen it slowly and carefully, trying to avoid spilling oil.

How to reset maintenance oil service light Honda Civic. From years: 2001, 2002, 2003, 2004, 2005. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).. Hold the button for at least 10 seconds, until the indicator resets..

Holding the funnel with one hand, use your other hand to pour in about 3.7 quarts of 5W-20 new motor oil. Eyeball it. It’s better to add too little at first because it’s always easier to add more rather than drain the extra oil. Once you’re done with that, screw back in the oil filler cap so that it’s a snug fit.

From the underside of the car, locate the oil filter. It will be installed on the engine block just above the driver side axle shaft. Keep the oil drain pan nearby as you reach up to get a grip on the oil filter. Loosen it slowly and carefully, trying to avoid spilling oil.

How to reset the service light on a Honda Pilot?

Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting). Hold the button for at least 10 seconds, until the indicator resets. Turn the ignition off and then start the engine to verify the indicator has been reset.