How to take anti-theft off a car radio?
Turn the key into the “On” position. The “Theft System” light begins flashing on the dashboard. Leave the key in this position for 10 minutes until the “Theft System” light stops flashing and goes off. Flip the key into the “Off” position and leave it there for five seconds.
What does theft lock do on a GM radio?
Theftlock is a theft prevention system designed into GM-brand radios starting in the mid-1990’s. This system is designed to lock the radio from use in the event of a loss of power, either from being disconnected or when the battery loses its charge.
What to do if your car radio is locked?
Start your vehicle like normal, or turn the key until it’s in the “On” or “Accessory” position. Then, press the power button on the radio’s volume dial to turn on the radio. The digital display will read “LOC” if the radio is locked.
How to unlock a Chevy TheftLock Radio Part 3?
Part 3 of 4: Obtain the radio unlock code 1 ) sign. 2 Enter the radio serial number. You will be prompted to enter the radio serial number you have just obtained. 3 Write down the radio unlock code. The prompt will read out your four-digit radio unlock code. Write it down precisely. …
Theftlock is a theft prevention system designed into GM-brand radios starting in the mid-1990’s. This system is designed to lock the radio from use in the event of a loss of power, either from being disconnected or when the battery loses its charge.
Is there a way to unlock a TheftLock radio?
Theftlock radios have evolved over time but are still used in some vehicles currently. Vehicles from the mid-90’s until mid-to late 2000’s can be unlocked using a few simple steps.
Is there a way to prevent theft of a car radio?
Many vehicle manufacturers hope to prevent theft by installing car radio alarms, sometimes known as PassLocks or Theftlocks. The lock is programmed either through the cars ignition, actual radio or electrical wiring or fuses.
How do I Reset my anti theft radio?
Press the “ON” button on the radio. The radio is now reset. Press the “Minute” and “Hour” buttons slowly until the security code matches. Going too fast may cause you to skip over the correct numbers of the security code. Store your radio security code in a safe place.
Where do I find anti theft protection activated?
On the way to the cottage the Audio 20 screen displayed the message: Anti-Theft Protection Activated – Please visit your nearest Mercedes-Benz dealer. This message appeared on both the smaller dash display and the larger Audio 20 display. I could not access phone, radio, media, system or anything else.
How are GPS and RFID used to prevent theft?
Abstract An embedded system based on the Global Positioning System, the GPS, and Radio frequency identification technology is developed to prevent automobile from theft. This consists of GSM, GPS, RFID & two sensors.
What to do if your anti theft system has lost power?
This system has lost power. Push and hold the power button for more than two seconds to enable the system. ” I assumed that the vehicle was directing me to hold the radio power button, so I did and held it for two seconds, but it made no difference.
What happens if your anti theft system is not working?
Before getting into how to disable your anti-theft system when it is not working right, we will get into what it actually does. Your anti-theft system, like the name implies, is to prevent your car from being able to be stolen.
How to disable anti-theft system in your car in the right?
Insert the key in the door lock all the way and then turn the key to unlock your car door, but don’t release it. You want to hold the key in the unlock position for twenty to thirty seconds. This lets the car recognize that you have the right key and will disengage and reset the system.
On the way to the cottage the Audio 20 screen displayed the message: Anti-Theft Protection Activated – Please visit your nearest Mercedes-Benz dealer. This message appeared on both the smaller dash display and the larger Audio 20 display. I could not access phone, radio, media, system or anything else.
Abstract An embedded system based on the Global Positioning System, the GPS, and Radio frequency identification technology is developed to prevent automobile from theft. This consists of GSM, GPS, RFID & two sensors.
Why is my car radio not working after a new battery?
Today the dealership did a tuneup, replaced the timing belt, and put in a new battery. I started my car and the radio did not work. They went out and reset the radio but said it would not reset, they check the fuses and said they were all good.
How to reset my Honda radio after putting in a new battery?
Step 1 Turn the ignition key to the “On” position, but don’t start the engine. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display. Release the power button when the display lights up and the radio turns on.
Is there a way to disarm the alarm on a car radio?
(This button is usually a “Tone” button or “Auto Program” button.) Verify the VIN number on the screen and follow the manual’s instructions on disarming the alarm on the radio. This will allow the radio to be used in other vehicles that do not have your car’s VIN number.
Today the dealership did a tuneup, replaced the timing belt, and put in a new battery. I started my car and the radio did not work. They went out and reset the radio but said it would not reset, they check the fuses and said they were all good.
Step 1 Turn the ignition key to the “On” position, but don’t start the engine. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display. Release the power button when the display lights up and the radio turns on.
Why is my anti theft system not working?
It is possible that the system can trigger the car alarm or prevent the engine from running without any apparent reason. You have to shut it off if it is not working properly. The car won’t return to normal operation unless you fix the issue of anti theft device car wont start. How to disengage anti-theft system? These tricks will help:
What to do if you have electrical issues after replacing a battery?
If you’re experiencing electrical issues immediately after a battery replacement or disconnect, make sure the battery cables were re-attached and tightened down properly. Herculean strength isn’t necessary, but the cables should be snug and not move around or come off of the battery posts.