What causes surging in a diesel engine?

What causes surging in a diesel engine?

If an engine is not getting enough fuel (this is called “running lean”), due to fuel pressure (regulated by the fuel pump and regulator), restricted fuel injectors, a vacuum leak or really anything that throws off the fuel mixture going in to the engine, this can cause the surge.

Why is my throttle going up and down?

Among the potential underlying causes are vacuum leaks, EGR system malfunctions, malfunctioning oxygen sensors, dirty fuel injectors, fuel pump malfunction, faulty spark plugs, a faulty mass airflow sensor, or a faulty throttle position sensor.

What causes an engine to surge at idle?

A surge is usually caused by a fuel system management or drivetrain operation failure. When an engine’s computer can “hunt” or “surge” at cruising or idle speeds it is searching for program compliance, there is a problem elsewhere in the system. SPONSORED LINKS. Article published 2017-01-26.

Can a bad throttle position sensor cause idle surging?

Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. 3) Check Engine Light

What happens when engine idle speed is above programmed range?

When the engine idle speed is either above or below the programmed range, the ECU prompts the ISC to either increase or decrease bypass airflow. Naturally, as the IAC prompts the throttle plate to open, engine speed increases. The IAC features a plunger mechanism that may be stuck/sticking.

What causes an engine surge when the ECU is off?

If closed TPS voltage changes, the ECU may assume that your foot is on the throttle, causing a richer fuel mixture to be delivered. This can also be caused by a faulty TPS, or even a poor ground. With the engine off, check TPS voltage with the accelerator pedal relaxed. Then work the pedal a few times and see if the voltage changes.