What does DPF indicator mean on Mitsubishi Fuso?
The DPF indicator flickers when the exhaust gas is not hot enough for automatic regeneration due to a traffic jam, etc. Stop the vehicle at a safe place, and press the DPF Cleaning Switch continuously to start manual regeneration of the filter.
How does automatic regeneration work in a Mitsubishi Fuso?
Automatic regeneration (Intervention of Driver is not needed.) The exhaust gas does not get hot enough for continuous regeneration during driving on urban streets, so the engine raises the temperature of exhaust gas to allow automatic regeneration.
When did cars start using the DPF system?
Cars since 2007 were using DPF as a way to meet and pass the stringent emissions regulations imposed in 1st world countries. (ie Manufacturers selling these same vehicles in countries such as China, India, South East Asia, South America etc do not have these Systems fitted)
How much does it cost to replace a DPF light?
For many years the only option for DPF equipped vehicles experiencing problems (ie DPF warning light on the dashboard of the car) was to replace the old blocked DPF with a Factory unit, costing upwards of $6000. Fitting a genuine factory part was not viable for most people.
Can you remove DPF off on Late Model Fuso Canter?
SUCCESS! Recently, we had a successful win removing the factory DPF and reprogramming the factory ECU to accept DPF Off on late model Fuso Canter. Tuners and programmers around the world know how difficult these were to decode the ECU and remove the DPF however testing now shows we cracked the procedure … first in the world.
When to start manual regeneration of diesel particulate filter?
Manual regeneration. The DPF indicator flickers when the exhaust gas is not hot enough for automatic regeneration due to a traffic jam, etc. Stop the vehicle at a safe place, and press the DPF Cleaning Switch continuously to start manual regeneration of the filter.
How long does Mitsubishi Fuso diagnostic code last?
The last digit of code will comes on for 0.4 seconds and turns off for 0.4 seconds. Light is turned off for 2.4 seconds between codes. When a minimum of two codes are to be displayed, one code is repeated three times, then next code will be displayed 2.8 seconds later.
How to reconnect memory clear switch Mitsubishi Fuso?
Reconnect memory clear switch to erase DTCs. 3. Mitsubishi Fuso: Diagnostic Trouble Code Interpretation Control unit turns light off for 2.4 seconds after diagnosis and displays the code. The first digit of code illumination for 1.2 seconds and turns off for 1.2 seconds.
What kind of scan tool does Mitsubishi Fuso use?
Fig. 8 Scan tool test connections. 1999–2005 Mitsubishi Fuso FE, FG, FK & FM Fig. 9 Scan tool test connections. Mitsubishi Fuso 2003–04 FH