What kind of fluid does Ford Explorer use?

What kind of fluid does Ford Explorer use?

Ford Mercon V is the fluid required for this transmission. In this video I show you how to fill and adjust the 5R55S after a repair that has required a fluid drain or loss. If you follow this procedure you will have no issues with the proper fill level of the 5R55S.

How can I find out what kind of transmission fluid I have?

Check your owner’s manual to ensure you have the right type of fluid for your car. Step 1: Park your vehicle and keep it running. It’s best to check transmission fluid when the engine is hot. Step 2: Open your hood release and locate the transmission dipstick. It looks a lot like your oil dipstick.

When is the best time to check transmission fluid?

It’s best to check transmission fluid when the engine is hot. Step 2: Open your hood release and locate the transmission dipstick. It looks a lot like your oil dipstick. Check your owner’s manual if you are not sure where to locate your transmission dipstick. Step 3: Remove the transmission dipstick and wipe it clean with your towel.

Why is transmission fluid leaking out of my vent tube?

Transmission fluid is leaking out of my transmission vent tube. Why is this? No engine code comes up when I run the obd 2 on it. I just replaced the solenoid pack in the transmission valve body today cuz I had that code.

How to start and stop a Ford 5R55?

Hold speed and throttle open and steady for a minimum of 15 seconds. With the transmission in 5th gear and maintaining a steady speed and throttle opening, lightly apply and release brake to operate brake lights. Then hold speed and throttle steady for a minimum of 5 seconds. Brake to a stop and remain stopped for a minimum of 20 seconds.

How to install a speed sensor on a Ford 5R55?

Install a funnel into the center speed sensor hole on top of the transmission. Pour in 8 quarts of ATF. Install speed sensors. Install the transmission in the vehicle. After installation, remove the 5/16” hex plug (this is the fill plug). Remove the T-30 torx plug from the center of the bottom of the pan drain plug.