What kind of fuel system did the 1980 Chevy 454 use?
A M4MC or EM4MC carburetor was used on most of the 1980 series engines. This is an aspirated fuel delivery system with the addition of a mixture control system controlled by the ECM.
How much horsepower does a Chevy 454 V-8 have?
The results: 567 horsepower and 537 pound-feet of torque on 89-octane pump gas! That represents a 70-percent increase in horsepower. That’s impressive! And remember, that’s all without touching the bottom end. Best of all, this engine will make that power all day long without the threat of grenading under the stress of a turbo or supercharger.
Where are the fuel injectors located in a 454 engine?
The throttle portion of both the TBI units may contain ports located above, or below the throttle valve. These ports generate the vacuum signals for the exhaust gas recirculation (EGR) valve, MAP sensor and the canister purger purge system. The fuel injectors are solenoid-operated device, controlled by the ECM.
Where is the fuel pump located in a 454 engine?
Evaporation emission control system. The injector fuel control systems have a electric fuel pump, located in the fuel tank on the gauge sending unit. It pumps fuel to the throttle body and the direct fuel injector system through the fuel supply line and then through an in-line fuel filter.
When did Chevy start using the 454 engine?
The LE8 454 was the most common from 1973 to 1991. The L19 TBI, or throttle body injection, powered 1987 and later trucks as the second 454 engine option. The TBI 454 had fuel injectors in the middle of the throttle body that increased fuel efficiency, power and durability. Chevy began installing 454 V-8s in its trucks in 1973.
What kind of gas mileage does a Chevy 454 get?
The 454 is a big-block carbureted engine found in most older model Chevrolet cars and trucks. The engine uses eight cylinders to provide high-end torque and speeds. The combination of larger bore and eight cylinders equates to very poor gas mileage. The engine runs an average of 10 to 15 mpg.
When did Chevy start using throttle body fuel injection?
The return of the 231 V-6 to General Motors cars in the mid-1970s proved that fuel efficiency could be achieved in compact engines. But in 1988, Chevrolet introduced Throttle Body Fuel Injection to the 454. It was the same TBI system used on small-block V-8s and the V-6s.
What should the idle RPM be on a Chevy 454 Eng?
You want the idle to be around 800 to 900 rpm with the vehicle in park and around 700 rpm with the vehicle in neutral. Monitor your tachometer while adjusting. Adjust the idle by sound if you do not have a tachometer. Listen for the engine rpm to drop until just before it starts to sputter.