What should the oil pressure be on a MaxxForce 13?

What should the oil pressure be on a MaxxForce 13?

Not really sure why someone would take the filter out and leave it out. Minimum safe oil pressure is 10 psi. 15 psi is fine. It is a bit lower than what is “typical”. Most are around the 20 psi mark. Minimum safe oil pressure is 10 psi. 15 psi is fine.

Where is the oil level sensor on MaxxForce 11?

12 ®2010 MaxxForce 11 and MaxxForce® 13 Engine Training Program System Sensors The engine oil level sensor is located on the lower left side of the crankcase. The ECM sends a signal to this sensor when the ignition is turned On and the engine is Off. The ECM measures the time it takes for the signal to return back to the ECM. Based on the engine

How to install Evans Waterless coolant in 2011 Navistar MaxxForce 13L?

INSTALLATION PROCEDURE–2011 Navistar MaxxForce 13L Procedure for installing Evans Waterless Coolant and a ResistorPac into a 2011 Navistar Max Force 13L engine equipped with an ECM-controlled modulating fan VER 05Nov2012 CAUTIONARY NOTE: DO NOT FLUSH COOLING SYSTEM WITH WATER!

Where is the petcock on a Navistar MaxxForce 13L?

Find its petcock on the left side. PETCOCK FOR LOW TEMP RADIATOR c. Apply air to the expansion tank, either from the Makita blower or from the cooling system pressure tester to speed the draining. d. Once the draining from the primary radiator slows,pull off the bottom radiator hose and leave it to drain. Leave the radiator petcocks open. 6.

Why is my MaxxForce 13 hard to start?

We find if it is really cold to turn on the key, let the cold start assist cycle, once the light starts to flash, turn the key off, then turn back on and let it cycle a second time for easier and faster starts. If it takes too long to build up fuel pressure because fuel is leaking back it will log a code right away.

Are there any recalls on ProStar MaxxForce 13?

2011 and 2012 had multiple recalls on the high pressure fuel pumps, Could be a fuel pump just going poof. And yes the motor is total junk, the company one I had was rebuilt 3 times in 420k we had the truck. WalterSobchak Thanks this.