Where is the starter button on a Harley Davidson?

Where is the starter button on a Harley Davidson?

Move the voltmeter’s red probe to the solenoid’s power input terminal, located on the top of the starter solenoid. Turn the ignition switch on and shift the motorcycle into neutral. Flip the engine stop switch, located on the right handlebar, into the “Run” position, then push the starter button for two seconds.

What happens when you press the starter button?

Battery is almost fully charged , what I had expected after 4 months of sitting. Also, press starter button with lights pointed on wall nearby no dimming of lights at all. Otherwords no load being put on battery. Will go play with it when it warms up a bit.

What to do when you press the starter button on a V twin?

You can jumper a wire from your battery positive post or the battery post on your starter to your green wire solenoid connection to see if the starter activates (make sure your in neutral and the ignition is shut off). If it does starter is ok and suspect the bad relay.

What kind of starter does a 2002 FXDX have?

2002 FXDX. Starter spins like a mother^&*, engages occasionally but then disengages and spins like a drill. If I tap tap tap the starter botton I could get it to engage afetr about 5 tries but it would release and not engage again.

Move the voltmeter’s red probe to the solenoid’s power input terminal, located on the top of the starter solenoid. Turn the ignition switch on and shift the motorcycle into neutral. Flip the engine stop switch, located on the right handlebar, into the “Run” position, then push the starter button for two seconds.

Where does the starter go on a V twin?

Occasionally the bike starts. When you hit the starter button, it sends 12 volts and about an amp or so to the 86 position on your starter relay.

2002 FXDX. Starter spins like a mother^&*, engages occasionally but then disengages and spins like a drill. If I tap tap tap the starter botton I could get it to engage afetr about 5 tries but it would release and not engage again.

What does it mean when Your starter won’t engage?

The solenoid is ok, otherwise the starter motor wouldn’t run. The jack shaft will not engage unless the clutch is good. Correction, the jack shaft will engage with the clutch ring gear, but will not turn the engine over if the overrunning clutch is slipping.