Why does a starter stick?
A typical starter/solenoid assembly is mounted in the lowest, dirtiest position on the engine. The “stickiness” is usually due to a combination of contaminates that cause either the solenoid plunger or the sliding pinion gear assembly to bind.
What causes a starter to stay running?
So, if your starter keep running, the problem could be stuck starter relay contacts, a continuous ground on the starter relay control coil, or a binding ignition lock cylinder that keeps the actually ignition switch in the START position. If the problem persists, it’s not a stuck relay.
What happens when starter stays engaged?
The small wire should only be powered when the key is turned to the start position, but if it stays powered up in the run position, the starter will stay engaged. If the starter solenoid sticks, the starter will stay running until it unsticks, or until the battery is disconnected.
What to do if your Toyota starter won’t start?
Specifically, they say that the contacts in the solenoid are a common problem with Toyota starters. These contacts may be repaired (parts & labor) for slightly less than the cost of a complete remanufactured starter (parts only). I could replace a starter, but I’m afraid to rebuild one.
What happens when you remove the starter from a Toyota Sienna?
Starter won’t stop — even if key removed! Starter sometimes fails to turn — sometimes won’t stop turning. The problem with my 2000 Sienna began as a zero response when turning the key to start the van. But with a second attempt the van would start just fine.
Why does my Ford starter keep running even after I Turn Off the engine?
Some Ford owners encounter a situation where the starter run continuously or keeps running even after the engine has started and even after they’ve removed the key from the ignition. At first, this may make you think the starter drive is binding. Or you may think you have a bad starter relay.
What happens when you stop pressing the starter button?
Starter stays on after engine started. When you start your engine and release the key or stop pressing the starter button on a modern vehicle, the circuit is supposed to close, which will discontinue power to the starter motor.