Why does traction control go off on my GMC Yukon?

Why does traction control go off on my GMC Yukon?

I had a 2011 Sierra that did similar and it was the steering wheel position sensor. At the time it was under warranty. It would come on and go off with no other symptoms. The dealership couldn’t find the issue.

When was the last time I serviced my GMC Yukon?

Last serviced at 148,132 miles in Oak Lawn, IL on 02/10/20 • Vehicle serviced • Maintenance inspection completed • Engine/powertrain computer/module reprogrammed. Mileage: 181,207 miles Body Type: SUV Color: Silver Engine: 8 Cyl 5.3 L No accident or damage reported to CARFAX. Purchased on 04/02/07 and owned in CA until .

Why is my brake switch not working on my Yukon?

Common issue with brake switch. Not sure it goes with the warnings you are seeing. Would definitely keep you cruise control from working though. See if you can get a code when the error messages show up. Steering Wheel Position sensor is a common cause of the intermittent issues like you are seeing. Might just be a bad ground.

What does TSB stand for in GMC Yukon?

Found TSB related to that code regarding corrosion fretting in the connector. Haven’t seen messages since it was replaced a few months ago. Sparksalot likes this.

I had a 2011 Sierra that did similar and it was the steering wheel position sensor. At the time it was under warranty. It would come on and go off with no other symptoms. The dealership couldn’t find the issue.

Common issue with brake switch. Not sure it goes with the warnings you are seeing. Would definitely keep you cruise control from working though. See if you can get a code when the error messages show up. Steering Wheel Position sensor is a common cause of the intermittent issues like you are seeing. Might just be a bad ground.

Found TSB related to that code regarding corrosion fretting in the connector. Haven’t seen messages since it was replaced a few months ago. Sparksalot likes this.

Why does my GMC Canyon have a StabiliTrak light?

If these lights appear, it generally means these important safety features are being disabled. This issue can happen at any time with any of the GM vehicles. We are currently working on a claim involving a 2012 GMC Canyon where the StabiliTrak light has come on five times within the first 5,000 mile period.

When does the ABS light come on on a GMC Yukon?

Your GMC Yukon’s ABS Light comes on when it fails a self diagnostic cycle. When on, it indicates that the Yukon does not have Anti-Lock brakes, and the safety they provide. Your Yukon’s ABS system uses a system of sensors to determine wheel speed when braking.

When to troubleshoot a GMC ABS brake system?

Instead, the ABS system will pump the brakes to provide better control over the vehicle for the driver. If you suspect you are having trouble with the GMC ABS brake system, you should troubleshoot the problem to verify whether there is a failure in the system. Open the fuse panel underneath the dash.

What does the brake light on a Yukon mean?

The brake light indicates that there is a problem with the physical braking system and that your Yukon is unsafe to drive. Yes, you can drive your Yukon with the ABS light on.

Why does my GMC ABS light keep coming on?

If the ABS dash light comes on and stays lit, and none of the ABS wires are damaged, it is likely that there is a partial failure in the ABS sensor. For specific information about GMC ABS braking systems, consult the particular vehicle’s manual (see Resources).