How do you change the stereo in a Honda Accord?

How do you change the stereo in a Honda Accord?

Use a panel tool to pry out the ignition switch panel to release the retaining clips, then disconnect the harness and remove the switch panel. Open the glove box door and pry out the upper glove box trim panel to release ten retaining clips and remove that panel.

How to reset a Honda Accord radio that says error E?

Careful, you only get three ⚟ tries. Don’t lose the code. The dealer needs your Radio Serial number. Get this by pressing and holding “1” & “6” together with the radio off. When one & six are being held, press the power button. The S/N:xxxxxxxx should display. Write down the serial number, a Disconnect Battery or Pull, and Reinstall Radio Fuse.

How do you remove the security system from a Honda Accord?

A two-pin connector for the Honda Accord’s security system. Strip the rubber or plastic insulators from both ends of the wire, and then push each end into the female slots of the wire harness. Use a plastic zip tie to fasten the connector to the frame or completely remove the connector by removing the six screws holding it in place. Figure 3.

How do you get the radio serial number on a Honda Accord?

Careful, you only get three ⚟ tries. Don’t lose the code. The dealer needs your Radio Serial number. Get this by pressing and holding “1” & “6” together with the radio off. When one & six are being held, press the power button. The S/N:xxxxxxxx should display. Write down the serial number, and show it to a Honda Dealer [speak with service] .

Use a panel tool to pry out the ignition switch panel to release the retaining clips, then disconnect the harness and remove the switch panel. Open the glove box door and pry out the upper glove box trim panel to release ten retaining clips and remove that panel.

Is the audio system in a Honda Accord good?

All in all, the stock stereos are pretty decent and Honda’s revised infotainment interface is getting positive reviews so far. If you have an Accord hybrid, the gas-electric hybrid powertrain and its very sensitive electronics will make upgrading the audio system a little more complicated. Here are a couple of things to keep in mind:

Where is the speaker on a Honda Accord?

Before you do anything to upgrade your Accord’s audio system, set the parking brake and disconnect the negative battery cable prevent any electrical short. Safety first, y’know. The speaker is attached to the center dash grille (Crutchfield Research Photo)

The Accord coupe’s doors are big and long, but the process of reaching the stock speakers is reasonably short. Push down on the screw cover release behind the door release handle, remove the cover, and remove the two exposed Phillips screws. Then, pull up the rubber mat inside the door pull cup and remove the exposed Phillips screw you see there.

What kind of audio system does the Honda Accord have?

A navigation receiver was a factory option on the Accord (Crutchfield Research Photo) The Accord sedan and coupe share the same dashboard design and factory radios. The standard piece was an AM/FM/CD/MP3/WMA player connected to six speakers. The Premium Audio system added a subwoofer for a total of seven speakers.

Where is the subwoofer located on a Honda Accord?

The Accord’s optional subwoofer, measuring roughly 8″ in diameter, is located between the two rear deck speakers. Unlike the speakers, it’s secured to a plate that’s welded to the rear deck steel, so getting to it and replacing it is a bit of a challenge.

Where does Satellite Radio plug in Honda Accord?

It plugs into the same plug where the satellite radio plugs into the back of the radio. So for my car, i unplugged the xm, and plugged in the ipod unit, then plugged the satellite radio plug into the extra side plug on the ipod interface cable.

Posted In Q&A