How do you replace the pulley on a water pump?
Step 1: Locate the water pump pulley. Find the pulleys to the engine and look for the pulley that goes to the water pump. Step 2: Remove any components in the way of the drive or serpentine belt. To access the drive or serpentine belt, you will need to remove any parts that are in the way.
How do you remove water pump from engine?
Remove the water pump mounting bolts completely from the water pump. Pull the water pump off the engine, and allow the remaining inner engine coolant to drain into the pan. Scrape the water pump mounting surface using a straight razor blade. Remove the old gasket material and residue from the water pump mounting surface.
How do you remove a drive belt from a water pump?
Loosen the three mounting bolts on the front of the water pump pulley using a ratchet and socket. Do not remove the bolts completely. Depress the belt tensioner assembly by placing a 3/8-inch-drive ratchet into the provided hole at the top of the tensioner. Remove the drive belt from the engine completely.
How to change a water pump on a 3.9 V6 Chevrolet engine?
How to Change a Water Pump on a 3.9 V6 Chevrolet Engine Step 1: Make sure the water pump needs to be replaced. Step 2: Remove all the items blocking access to the water pump. Step 3: Loosen the four bolts securing the pulley to the water pump. Step 4: Remove the serpentine belt.
Should the water pump turn freely?
It should turn freely but not feel loose or rough; otherwise, replace the water pump. On vehicles where the radiator fan attaches to the water pump assembly; you can grab the fan and carefully wiggle the fan. If you notice movement, most likely the water pump will need replacing, but check that all mounting bolts are tight.
Does Waterpump push or pull water?
The water pump definitely pushes water through the engine. There is a fair chance the lost vanes (or the remants of them) are somewhere in the cooling system.
How do you remove Pully from power steering pump?
To remove the pulley from the power steering pump, a special power steering pump pulley puller is required. Remove the power steering belt. Loosen the tensioning bolt and push the power steering pump toward the engine. Then remove the belt.
How do you pull a deep well pump?
Steps Turn off power to the pump. Mount a hand-crank winch in such a way as to lift the pump out partway. Hook the winch to the flange that connects flexible pipe to the storage or pressure tank. Winch the pump so that there’s a few feet of the flexible pipe outside the casing.
Step 1: Locate the water pump pulley. Find the pulleys to the engine and look for the pulley that goes to the water pump. Step 2: Remove any components in the way of the drive or serpentine belt. To access the drive or serpentine belt, you will need to remove any parts that are in the way.
What happens when a water pump pulley goes bad?
As the water pump pulley wears out, it tends to widen, making the belt slip. Cracks can also form on the pulley if the bolts come loose or the pulley has too much stress applied to it. Additionally, the pulley can bend if the belt is at an angle because of an accessory that is not aligned properly.
Can a multi groove pulley drive a serpentine belt?
A multi-groove pulley is a multi-depth pulley that can only drive a serpentine belt. The serpentine belt is useful because it can be driven on its front and back sides. The serpentine belt design serves well, but when a pulley breaks or the belt breaks off, then all of the accessories, including the water pump, fail.