How much torque does a Buick axle nut have?
Make and Model > Buick > Allure > Buick Axle Nut Torque Specifi… 2016-2017 Tighten to 111 ft-lbs/150 Nm. Back off 45 degrees and retighten to 184 ft-lbs/250 Nm. 1992-1995 103/140-ft/lbs/Nm After tightening to this value, turn an additional 20°. 2013-2017 FRONT 37/50-ft/lbs/Nm Use new nut.
How to replace the front wheel on a 2002 Buick Century?
Tighten the wheel bearing mounting bolts to 96 foot-pounds with a 1/2-inch drive torque wrench and socket. Tighten the axle nut to 118 foot-pounds of torque with the torque wrench and spindle nut socket. Install the brake rotor, and spin one lug nut on by hand to hold the rotor in place. Install the tie rod back onto the steering knuckle.
What kind of engine does a 2002 Buick Century have?
The 2002 Buick Century was available in the Custom and Limited trim packages. Both 2002 Century sub-models were equipped with a 3.1-liter V-6, which produced up to 175 horsepower and 195 foot-pounds of torque. The wheel bearings on the 2002 Century can wear out over time, causing them to need replacement.
How much torque does a hub bearing have?
Hub Bearing Torque Specification Guide 2010 Make year Model Front torque ft-lbs/Nm Rear torque ft-lbs/Nm
What are torque specifications for front and rear axles?
Torque specification guide Front & rear axle nut torque specifications for FWD, RWD & 4 W/D vehicles One of the most common mistakes during installation is improper torque of the Axle nut. To guarantee the (Bearing, Spindle or Hub) is torqued correctly, follow the manufacture’s installation procedure.
Make and Model > Buick > Allure > Buick Axle Nut Torque Specifi… 2016-2017 Tighten to 111 ft-lbs/150 Nm. Back off 45 degrees and retighten to 184 ft-lbs/250 Nm. 1992-1995 103/140-ft/lbs/Nm After tightening to this value, turn an additional 20°. 2013-2017 FRONT 37/50-ft/lbs/Nm Use new nut.
Where can I find the torque specification guide?
Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life. Under torque of an axle nut will allow excessive movement causing uneven loading and excessive wear.
What happens when an axle nut is over torque?
Under torque of an axle nut will allow excessive movement causing uneven loading and excessive wear. Over torque of the axle nut will cause excessive load and cause the bearing to overheat, this is one of the most common causes for failures.