How to fix Honda Civic engine code p1298?

How do I fix code P1298 HONDA Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. P1298 HONDA Tech Notes There is a factory service bulletin for the following Honda models: – 2001–2005 Honda Civic

How to reset the p1298 load detector code?

Connect the scanner to the vehicle diagnostic connector and retrieve stored codes and freeze frame data. Write it down as it will almost always come in handy if the diagnosis drags on due to an intermittent condition. Clear the codes and operate the vehicle under various electrical load conditions to see if the code P1298 is reset.

What does error code p1298 mean on Eld?

Error Code P1298 is defined as Electric Load Detector Circuit High Voltage. This means the ELD (Electric Load Detector) is getting high input voltage. This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present.

When does a PCM get a code p1298?

If the PCM detects a voltage signal from the ELD circuit that is greater than the degree of voltage it expected the alternator to produce at a given time and under a specific set of circumstances, a code P1298 will be stored and a malfunction indicator lamp (MIL) may be illuminated. What are the common causes of code P1298?

How much does it cost to fix a p1298 Honda?

What does this mean? The cost of diagnosing the P1298 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

What to do if your Honda code is not working?

A guide on how to check your codes: If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.

What is the fault code for a Honda Accord?

P1297 Electric Load Detector (ELD) Circuit Low Voltage P1298 Electric Load Detector (ELD) Circuit High Voltage P1300 Random Misfire P1324 Knock Sensor Power Source Circuit Low Voltage P1336 Engine Speed (RPM) Fluctuation Sensor Intermittent Interruption P1337 Engine Speed (RPM) Fluctuation Sensor No Signal

What does the p1298 Honda electric load detector do?

P1298 HONDA Meaning. The Electric Load Detector (ELD) measures the main current flow and sends that signal to the Engine Control Module (ECM) to command the alternator charging system to get fuel efficiency and decrease the drag of the engine when starting.

How long to diagnose Honda engine code p1298?

To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later. The cost of diagnosing the P1298 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

What is the error code for Honda Civic?

This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present. Rather, it applies to select vehicle manufacturers, most commonly among Honda vehicles like Honda Accord, Honda Civic, and Honda CR-V.

How much does it cost to repair a Honda engine code?

The cost to diagnose the P1298 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What does p1298 stand for in Honda Eld?

It is very likely that the symptoms which the vehicle in question is exhibiting, as well as the stored code P1298, are the subject of a factory technical service bulletin (TSB). The ELD used in Honda vehicles has demonstrated a proclivity for failure.

How to check the p1298 high voltage code?

Clear the codes and operate the vehicle under various electrical load conditions to see if the code P1298 is reset. Observe the data display on the scanner while using the DVOM to test live voltage data at the alternator.

How much does it cost to diagnose a Honda engine code?

The cost to diagnose the P1298 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

What does P1167 stand for in EVAP code?

The heater element is on until the engine is at normal operating temp then it switched off. P1167 is the upstream O2 sensor just before the cat. If it is anything like a evap code where the computer has to relearn the sensors parameters under varying load conditions by doing tests etc.

What does the book say about p1166 and P1167?

The book says that both P1166 and p1167 is defined as the primary air/fuel sensor heater malfunction (not secondary). – shuva Nov 3 ’17 at 6:46 The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM).

How do you replace Ignition Control Module on Honda Civic?

Remove two Phillips screws underneath the ICM to replace it. Simply install the new ICM with the same screws. Reattach the wires connecting the ICM to the distributor housing. Reattach the inner cover and rotor. Secure the rotor with the Phillips screw. Reattach and secure the distributor cap.

What does the P1167 Honda engine code mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P1167 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

When does the gauge control module set the OBDII code?

The Gauge Control Module sets the OBDII code when the Powertrain Control Module ( PCM) communication is not to factory specifications. Need more information on how to fix the B1168 HONDA code?

How much does it cost to repair a B1168 Honda?

The cost of diagnosing the B1168 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

How much does a gauge control module cost?

Most auto repair shops charge between $75 and $150 per hour. The Gauge Control Module monitors the Powertrain Control Module ( PCM ). The Gauge Control Module sets the OBDII code when the Powertrain Control Module ( PCM) communication is not to factory specifications.

What does the p0505 Honda engine code mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P0505 HONDA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

What does p1298 mean on Honda Charger?

If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit. This code specifically pertains to a condition in which a voltage signal that is higher than anticipated has been perceived.

Can a Honda Civic have a high voltage Eld?

Alternator failure will rarely result in a high voltage condition at the ELD but follow the guidelines set forth in the vehicle information source and corresponding TSB/s for diagnosing and repairing charging system malfunctions for the specific vehicle in question. 2002 Honda Civic 38k miles and I don’t drive it too hard.

What happens when you get the error code p1298?

As with other error codes, this code sets the Check Engine light and registers the error code. Usually, there are no other noticeable symptoms. In some cases, however, the engine may suffer rough idle, especially when the vehicle settles down or transitions from high throttle to rest, or the engine feels like it’s misfiring.

What does error code p1298 mean on electric load detector?

Other manufacturers with the same error code may have different specifications on the definition, troubleshooting, and repairs for this code. The Electric Load Detector works by monitoring the amount of current that the charging system is using, so it can determine how much voltage needed to charge the battery.

What does Eld code p1298 stand for?

This code specifically pertains to a condition in which a voltage signal that is higher than anticipated has been perceived. In my experience, only Honda vehicles utilize this type of ELD device or code P1298.

How much does it cost to fix a Honda engine code p1298?

The cost of diagnosing the P1298 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

What causes faulty electronic load detector in Honda?

P1298 HONDA Possible Causes Faulty Electronic Load Detector Unit Faulty Engine Control Module (ECM) Electronic Load Detector Unit harness is open or shorted Electronic Load Detector Unit circuit poor electrical connection

Where can I find p1298 Eld circuit high voltage manual?

The P1298 ELD circuit high voltage exits in these vehicles: Alldatadiy.com and Eautorepair.net are professional-grade shop manuals—period. They include wiring diagrams and technical service bulletins. In most cases, their diagrams are right from the factory manuals.

Which is Honda load detector has high voltage?

P1298 – Electric Load Detector Circuit High Voltage (Honda) Trouble Code Fault Location P1298 Electric Load Detector Circuit High Volt

Navigation