What is a drivers door module?
Door Control Modules are placed inside both doors. They manage all actuators in the driver- or passenger door and are directly connected to a separate switch panel. Central Locking, Window Winders as well as Mirror Adjustment are controlled by this ECU.
How to replace driver door module and passenger door?
Position the door module in the hole on the door panel. Check that the lower mounting for the door module is correctly located in the support on the door panel Press the door module into place Connect the connectors Install the nut and screw Install the door panel.
How do you remove a door control module?
Pull the door module backwards and upwards. Remove the door module from its mounting on the door panel Press up the door module. To remove the upper panel, see Removing the upper panel. Page 1 of 4 Check Check that the control module connectors are intact. Installing the control module
Where is the door module located on a car?
This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM). Position the door module in the hole on the door panel.
Do you have to replace a door control module?
If you said “yes” to all of those, then it’s almost certain you’ll have to replace the module. If you want to check the fuse boxes behind the dash panel, and on the driver’s side of the trunk, you can; however, it’s likely you’ll search in vain for that blown fuse. All right, so the good news is that you don’t always need to buy a new module.
How do you remove the passenger door module?
This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM). The illustration shows the driver door module (DDM). Ignition off Remove the door panel Remove the nut and screw holding the door module Disconnect the connectors Pry up the rear edge of the door module.
When to replace the driver door module ( DDM )?
Replacing the driver door module (DDM) and passenger door module (PDM) Preparations Caution!€New software can only be ordered after the control module has been installed in the car. VADIS reads off the new control module identity which is required to order the correct software.
This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM). Position the door module in the hole on the door panel.