What is the low coolant level sensor on a Cummins m2?
General Information The three-wire low coolant level sensor (CAS 700685 001) on some M2 vehicles built from 2007 to October 8, 2009, with Cummins ISB and ISC engines, may develop an internal leak, causing the engine light to illuminate and the engine to shut down.
How to check engine and engine protect light?
Check engine and engine protect light comes on engine will run then shuts off . engine will not stay running . engine will shut off . I suspect your engine management computer has detected something out of whack and continuing to run the engine may ruin it. I would check the oil and coolant levels.
What causes a fault on a Freightliner M2?
There is no power to the transmission with the engine running. The power supply is not properly grounded. The transmission needs to be recalibrated. The transmission needs to be recalibrated. The transmission needs to be recalibrated. The transmission needs to be recalibrated. The TCU is shorted to ground. The TCU has an open circuit.
How often does Freightliner engineprotect light come on?
35 people found this helpful. I have a2002 Freightliner engineprotect light comes on every now and then but has not shut off yet not sure what it may be is ecm going out have not driven truck far do you have any ideals 49 people found this helpful.
What should I do about coolant in my Cummins Engine?
Answer: Follow Cummins recommendations in Cummins Owner窶冱 Manual which was supplied with your bus and Cummins Coolant Requirements and Maintenance Service Bulletin 3666132. 6. Question: Who should a customer contact with questions on Cummins coolants in Cummins engines?
Is it OK to mix Cummins coolant with Blue Bird?
Cummins has published Technical Bulletin TB03/05-2 entitled “Compatibility of Fleetguard Coolants and SCAs with competitor Products “(attached). Although it is acceptable to mix any of the Fleetguard coolants listed below in a Cummins engine in a Blue Bird chassis, Blue Bird recommends that mixing be avoided if at all possible.
What kind of coolant do you use in heavy duty engines?
Partially formulated antifreeze/coolant does not meet American Society for Testing and Materials (ASTM) D6210. Treated Water Coolant Water containing all additives necessary for use as a coolant in heavy duty engines. Treated water coolant does not contain glycol or glycerin.