What is the PMS screw?

What is the PMS screw?

The PMS screws taper to a point. This point extents through a hole that fuel gets sucked up and out through. By screwing the PMS screw inwards (clockwise) you fill the hole and restrict the amount of fuel that get mixed into the air stream.

How do you adjust the clutch on a Yamaha V-Star 1100?

Adjusting the Clutch Cable – Lower End

  1. Loosen the adjustment at the clutch lever.
  2. Remove:
  3. – Left Side Cover.
  4. – Clutch Adjusting Cover.
  5. Loosen the locknut.
  6. Turn the adjusting screw in until it is lightly seated – Be careful, the screw will keep turning with enough pressure.
  7. Turn the adjusting screw out 1/4 of a turn.

Is a Yamaha V-Star 1100 a good bike?

It may not deliver the grunt of Yamaha’s 1600cc pushrod V-twin Road Star or approach the Royal Star in visual refinements, but the V-Star 1100 is an extremely well-balanced, middle-of-the-road motorcycle. In our opinion, it’s the best package being offered in the 1100 class this year.

How do I know if my carbs need balancing?

It’s best to go by the service schedule, but balancing carbs can be a fiddly job, so many owners understandably ignore it. If the engine isn’t idling very well, that could be a sign that you need to do it. And if you adjust the valve clearances, you’ll definitely need to.

Do you need to tune the carburetor on a Yamaha V-Star 1100?

While many modern V-twin motorcycles have gone to fuel injection, Yamaha’s V-Star 1100 is carbureted. All carburetors need maintenance from time to time. Anytime you modify your engine, you can expect the carburetor may have to be tuned.

Where is the throttle cable on a Yamaha V-Star 1100?

The V-Star 1100 has one choke cable and two throttle cables. Figure D shows the screw that holds the choke cable. Loosen this screw with you Philips screwdriver, and then the cable can be released by actuating the choke linkage, shown red in Figure D, by hand and sliding the cable end out through the bottom of the choke cam.

When to press the starter button on a V Star 1100?

When starting your V Star 1100, it is better to leave the starter button depressed until it starts, or up to around 15-20 seconds. Pressing it for just a few seconds and letting off you are more likely to cause the motor to kick back and damage your starter clutch.

How does a V Star carburetor work?

Your V-Star’s carburetors have a venturi that air flows through. The air is modulated by the carburetor slide. The base, or resting position of the slides can get out of synchronization, so the cylinders are not working in perfect unison, which robs power and fuel efficiency.

Posted In Q&A