What is the problem with GMC Sierra headlights?

What is the problem with GMC Sierra headlights?

THE LIGHTING DISTANCE IS INADEQUATE AND IS SO DIRECTIONAL THAT THERE IS NO SIDE FLAIR LIGHTING FOR TURNING LIKE YOU HAVE WITH CONVENTIONAL HEADLIGHTS. THIS IS A SERIOUS SAFETY ISSUE AND NEEDS TO BE ADDRESSED IMMEDIATELY BY THE NHTSA. I HAVE HAD THIS VEHICLE FOR 1 1/2 YEARS AND THE PROBLEM IS ONGOING SINCE I BOUGHT IT. THE DEALER HAS NO SOLUTION.

What are the most common intermittent wiper failures?

The two most common failures are: 1 A broken turn signal “canceling” mechanism that won’t shut off the “blinkers” after a turn, 2 A partial or complete loss of intermittent wiper control. More …

Can a new LED flasher prevent hyperflashing?

To prevent hyperflashing, the new LED bulbs would require load resistors. If you don’t want to go this route, you can replace your flasher with an led electronic flasher in your fuse box. Please compare your flasher to our flashers online to determine the one needed for your vehicle.

What kind of light bulb does a GMC Sierra use?

GMC replacement bulb guide Model Year Low beam High beam Fog/Driving light With sealed beam 2017 – 2003 H6054 – – Sierra 2013 H11 9005/HB3 5202 – 2012 – 2007 H11 9005/HB3 5202 – 2006 – 2003 9006/HB4 9005/HB3 9145/H10

The two most common failures are: 1 A broken turn signal “canceling” mechanism that won’t shut off the “blinkers” after a turn, 2 A partial or complete loss of intermittent wiper control. More

Is there a high beam relay on a GM Truck?

Guys, I don’t see a high beam relay, there is a low beam relay, but no high beam. If the bulbs are good, the next check is to see if there is voltage at the sockets. Guys, I don’t see a high beam relay, there is a low beam relay, but no high beam. If the bulbs are good, the next check is to see if there is voltage at the sockets. Click to expand…

What should I do about my 2015 GMC Sierra?

Best Headlight Upgrade 2015 Sierra – This is a vehicle specific upgrade. Not cheap, but way less than replacement lamp assemblies. I took mine to my GMC dealer and they installed for $200. Worth the cost. Read reviews of repair shops in your area. Enter your zip code: The headlights on these trucks are the absolute worst I have ever experienced!

Is the GMC Sierra 2500 projector lights bad?

Extremely dangerous to all in the truck. Surface Dept. where the truck was purchased new claims they are not aware of ant fix for the lights. Recently leased a new Chevy Silverado 1500 and the difference in the performance as compared to the 2015 is night and day due to the lighting of my 2500HD GMC it is an accident waiting to happen.

Where to replace LED light bulbs on GMC Sierra 1500?

The contact stated that the vehicle was taken to varney Buick GMC Mazda (260 hogan rd, bangor, me 04401) where the bulbs were replaced under a technical service bulletin however, the bulb replacement failed to fix the failure. The contact stated that he replaced the bulbs twice with led bulbs however, the failure persisted.

What kind of warning lights are on a GMC Yukon?

They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray). There are over 40 of them, so search carefully! Models examined include Acadia, Savana, Sierra, Terrain, and Yukon.

Why does my GMC Sierra airbag light go bad?

I did some research – and it turns out that these trucks and the SUV’s of the same era like to have front impact sensors that go bad. The sensors like to corrode because they are under the truck in the harsh weather conditions. To fix this error – you need to disconnect both batteries, drop the skid plate, and replace the Front Impact sensor.

How many GMC cab roof lights are there?

Only 14 left in stock (more on the way). . Only 5 left in stock – order soon. . . . Only 8 left in stock – order soon. . Only 14 left in stock – order soon.

Why is the intermitent blinking on my GM Truck?

I did a bit of looking into this, and according to GM, the P1638 sets if the PCM is not getting the correct signal for the alternator load, and they suggest checking the connections at the alternator and at the PCM.

Posted In Q&A