What is the yellow light on a GM starter interrupt?

What is the yellow light on a GM starter interrupt?

In this article, we are concentrating on factory-installed GM starter interrupt systems. This type of anti-theft system is designed to prevent the vehicle from starting unless the correct ignition key is used. These systems used a dash-mounted “security” or “theft” light which can be yellow or red in color.

What should I do if my GM security light is flashing?

Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2.

How can I disable the starter interrupt relay?

To disable (or start), turn ignition on, then press the hidden switch, then start as normal. You can substitute the switch with a number of others devices such as the amp turn on wire of your head unit. Be sure to isolate it with at least a 1 amp diode. Turn the key to the run position.

Is the starter interrupt warning light on or off?

Depending on the current status of the system, the warning light will be off, on steady, or flashing. Although they may share the same dash-mounted warning light, these “starter interrupt” anti-theft systems work separately from and independently of the “content theft” systems available from factory and aftermarket suppliers.

Where is the ignition switch on a GM PassLock?

Pull the radio out of it’s cavity. Disconnect the wiring connector and the antenna wire, and set the radio aside. On the left side of the radio cavity, there will be an opening, through which you will be able to see the Ignition Switch.

When does the Toyota Corolla security light go off?

If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine.

What to do if your PassLock light does not turn on?

Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)

Pull the radio out of it’s cavity. Disconnect the wiring connector and the antenna wire, and set the radio aside. On the left side of the radio cavity, there will be an opening, through which you will be able to see the Ignition Switch.

When does the security indicator light turn off?

Observe the “SECURITY” indicator After 10 minutes the “SECURITY” indicator light will turn off. Observe the “SECURITY” indicator After 10 minutes the “SECURITY” indicator light will turn off. Observe the “SECURITY” indicator After 10 minutes the “SECURITY” indicator light will turn off. Vehicle has now learned the new password. Start the

How to turn on security light without starting engine?

Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.

Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)

In this article, we are concentrating on factory-installed GM starter interrupt systems. This type of anti-theft system is designed to prevent the vehicle from starting unless the correct ignition key is used. These systems used a dash-mounted “security” or “theft” light which can be yellow or red in color.

What kind of security system does GM use?

VATS, Passkey or Passlock – are the core of GM security systems, have a short lifespan and they’re certainly more effective at keeping you from DRIVING your car than keeping someone from STEALING your car! GM Security Systems are killing cars all over North America and the only final solution is to disable and remove them permanently.

Who is the owner of the GMC Sonoma?

GENERAL MOTORS, GM, the GM Emblem, GMC, the GMC Emblem and the name SONOMA are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes in the product after that time without further notice.

What are the problems with the GM PassLock system?

If you decide to bypass your Passlock system, please contact us with the outcome so that we can pass the information along. By far, the most common problem with the VATS system is broken wires in the steering column. These wires connect the ignition lock cylinder to the under-dash wire harness.

Posted In Q&A