What years did Polaris make the 500 HO?
The Polaris Sportsman 500 H.O. was a 4-Stroke Single Cylinder, Liquid-cooled ATV produced by Polaris between 2006 and 2013.
How do you start a Polaris Ranger 500?
Starting Engine
- Sit in the driver’s seat and fasten the seat belt.
- Apply the brakes.
- Engage the park brake.
- Shift the transmission to neutral.
- Turn the ignition key past the ON/RUN position to START.
- If the engine does not start within five seconds, release the ignition.
What should I do if I give my Polaris 500 gas?
Re: Polaris 500, starts fine but when you give it gas is… Check the exhaust lobe on the cam. these are prone to wear if oil changes are neglected. try to run it with the airbox lid removed and see if there is any change. You can’t post conmments that contain an email address.
Why are the spark plugs on my Polaris 500 turning black?
It keeps dry fouling the plugs, they are jet black. It was running fine then all of a sudden started doing this. Checked spark and it looks good, any advice?
What should I do about my sportsman 500?
Check the exhaust lobe on the cam. these are prone to wear if oil changes are neglected. try to run it with the airbox lid removed and see if there is any change. You can’t post conmments that contain an email address. Trying to find answers to codes on my 2008 Sportsman 500 EFI HUD and fuel gauge flash ; codes count as 1-3-6-1 .
When did the Polaris Sportsman 500 Ho start?
I keep a 2009 Polaris Sportsman 500 HO up at the farm. Since there was very little snow this winter, I used it on every visit up until January. I tried to start the machine the first week of February and she wouldn’t start.
Re: Polaris 500, starts fine but when you give it gas is… Check the exhaust lobe on the cam. these are prone to wear if oil changes are neglected. try to run it with the airbox lid removed and see if there is any change. You can’t post conmments that contain an email address.
Why does my Polaris Sportsman 500 not start?
Returned yesterday with a new battery and installed it. The machine cranks fine, but will not start. Gas is full and non-ox is always used. On/Stop switch is “on”. Everything on the dash lights up properly. Nothing else has changed with the machine since it was parked last and was running.
It keeps dry fouling the plugs, they are jet black. It was running fine then all of a sudden started doing this. Checked spark and it looks good, any advice?