Where is the ECM fuse located on a 2010 Chevy Traverse?
The underhood fuse block is located in the engine compartment, on the passenger side of the vehicle….Engine Compartment Fuse Block.
| Fuses | Description |
|---|---|
| ECM | Engine Control Module |
| ECM 1 | Engine Control Module 1 |
| EMISSION 1 | Emission 1 |
| EMISSION 2 | Emission 2 |
Where is the transmission control module located on a 2010 Chevy Traverse?
It’s located in and goes through the front pan, basically just behind the radiator under the big plastic trans cover.
Why does my Chevy Traverse have reduced engine power?
Most of the time, reduced engine power doesn’t make commuting home possible since the max speed your Chevy Traverse will reach is not going to be enough to keep you safe on the highway. If your Traverse has gotten this reduced engine power warning, it means that one of its engine management sensors or the ECU have gone bad.
Are there any problems with my 2010 traverse?
Search CarComplaints.com for these popular complaint phrases… Here is another 2010 traverse with a blown engine at 66,500 miles. Car was serviced regularly , oil changed with more than 50% oil life remaining, according to the computer. Major problems started when warranty ran out.
When did the Check Engine light go off on my Chevy Traverse?
At roughly 79900 miles, the check engine light would come on and go off. It never stayed lit at all times. I had an appointment to have it checked, but the night before it was to go to the shop, the low oil, stop engine came across the dash and the bell started at 79983 miles.
What was the mileage on my Chevy Traverse?
I had an appointment to have it checked, but the night before it was to go to the shop, the low oil, stop engine came across the dash and the bell started at 79983 miles. The engine was sounding as if there was no oil at times and then everything would go off and it would run fine.