Where is the SRS light on a Honda Accord?

It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires. The SRS Light will come back on.

How do you turn off the SRS light?

MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.

Where is the fuse on a Honda Accord SRS?

Pull down on the fuse panel cover under the steering column with your fingers to remove it. Locate the small yellow plug in the fuse panel. This is the SRS power connector. Unplug the power connector from the fuse panel.

Why does my Honda SRS light keep blinking?

The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.

How to reset my Honda Accord after changing an alarm?

Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position. The alarm should now be disabled. Start your Honda Accord’s engine and allow the vehicle to run for at least 10 minutes. This will allow the Accord to reset the alarm.

How do you change the battery in a Honda Accord?

Lester Moorman, If possible charge your battery 12.2V+ or change it, as this could continue happening. Try alarm rest procedure below. Insert the ignition key in the Accord’s driver-side door lock. Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position.

Where is the seat belt sensor in a car?

The seat belt sensor can usually be found in a vehicle’s SRS airbag module, sometimes referred to as the ECU, or engine control unit. The SRS airbag module or ECU is usually located beneath the driver’s or front passenger’s seat, but it can be found in a few different locations as well.

Can a faulty seat sensor cause an airbag light to come on?

Before you decide to bypass the passenger seat sensor, use an airbag scanner to verify that the airbag light is due to the seat weight sensor. If yes, call your dealer to check if there is a recall on these problems. Most car manufacturers will replace the passenger seat sensor free of charge even if they are out of warranty.

Where is the SRS airbag module located in a car?

The SRS airbag module or ECU is usually located beneath the driver’s or front passenger’s seat, but it can be found in a few different locations as well. In some vehicles, it is found in the center console, kick panel, behind the steering wheel, or under the radio.

What does SRS warning light on dashboard look like?

The SRS warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with a large circle (the airbag) in front of the person.

Why is my SRS light not working on my Honda Civic?

I recently had this issue with my 1999 Civic SiR, and it turned out the issue was that the internal contact points of the car horn had corroded. Replacing the car horn, and then resetting the SRS light by disconnecting the battery for about 10 or so minutes fixed things.

Where is the SRS airbag control module located?

In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.

What should I do when my SRS light goes off?

When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal. The SRS Light should illuminate for a couple of seconds as normal and then go off.

What does the SRS light on airbags mean?

The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.

How much does a 2000 Honda Accord weigh?

2000 Honda Accord Sedan Change Vehicle. Vehicle Specifications. Curb Weight (lbs., MT/AT): 3064/3120. EPA Mileage Estimates*/Fuel Capacity (4 Speed Automatic EX)

How much horsepower does a Honda Accord have?

* 148-hp @5700/148 lb.-ft. @4900 ULEV-rated engine available in California and parts of the Northeast. **Mileage figures shown for comparison only.

The SRS light should go off. When the light goes off, pull the wires apart. The SRS light should blink twice. Turn off the ignition to start your car as normal. The SRS light should come on, and after a few seconds it will turn off and stay off. Figure 1. Connect a pair of stripped wires to short the MES. Figure 2.

What happens when the SRS light goes off?

The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal.

What does SRS stand for in Honda Civic?

Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.

Is there a way to reset the SRS light?

That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.

How can I tell if my SRS light is on?

The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.

What does the SRS light mean on a Honda Accord?

How many fuses are in a 2001 Honda Accord?

Honda Accord (2001) – fuse box diagram – Auto Genius Honda Accord (2001) – fuse box diagram Year of production: 2001 Fuse block (Engine compartment) Number Ampere rating [A] Circuits Protected 1 20 Left Headlight 2 (7,5) (DIMMER RELAY) 3 20 Right Headlight 4 20 ABS F/S 5 20 Stop 6 15 ACG 7 30 ABS Motor 8 15 Hazard 9 — Spare Fuse 10 …

Where is the MES plug on a Honda Accord?

1. Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. 2. Unplug the MES Plug. It should look like this. 3. Insert one end of speaker wire into MES Plug (one wire in each contact) 4.

When did the Honda Accord alarm go off?

This article applies to the Honda Accord (1990-2002). Despite Honda’s reputation for reliability, certain Honda Accord models also have a tendency to experience security system malfunctions. This can be quite problematic when the alarm randomly goes off at four in the morning, waking up your family and your neighbors.

How do you remove the security system from a Honda Accord?

A two-pin connector for the Honda Accord’s security system. Strip the rubber or plastic insulators from both ends of the wire, and then push each end into the female slots of the wire harness. Use a plastic zip tie to fasten the connector to the frame or completely remove the connector by removing the six screws holding it in place. Figure 3.

What are the warning lights on a Honda Accord?

What follows is easily the most complete list available of symbols and warnings that may appear in and on your car’s dashboard or instrument cluster. The following are warning lights and indicators found in vehicles built by Honda. Click a link to learn more about each one.

What does SRS mean when you turn on a Honda Accord?

The SRS, or supplemental restraint system, on your Honda Accord is responsible for deploying the airbag in the event of an accident. If this system is malfunctioning, the airbag may not deploy properly during an accident.

What does the SRS light mean on my Honda?

The SRS light on a Honda accord is an indication that there is a problem with the Supplemental Restraint System. Well, there could be a problem. Honda Accord, Civic, Prelude and CRV all are known to have continuous problems with the SRS system.

What does SRS stand for in Honda Accord?

This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system , or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.

Why does the SRS light stay on?

If you see the SRS light on, you must work to know why. It can be due to a variety of reasons including: The malfunctioning of airbag sensors: It is common for the sensors to fail. This may cause the sensor to activate all of a sudden for no reason, causing the airbag light to stay on. Replacing the sensors may do the job.

Why is my Fuse not working on my Honda Accord?

If you are getting around 12.5 volts on only one test tab, then the fuse is blown and should be replaced. If you aren’t getting around 12.5 volts on either of the test tabs, then the fuse is not getting voltage from the battery. Further testing will be needed to determine why the fuse is not getting power from the battery. Figure 5.

What kind of fuse box does a Honda Accord have?

Check out this fuse box guide for your Honda Accord to help you figure out what fuse does what. This article applies to the Honda Accord (1990-2002). Opening a fuse box can be bewildering. There are often dozens of multicolored fuses, which are all different sizes and all serve a different purpose.

It is under the driver’s side dashboard near the fuse panel. The harness is yellow and has two wires coming out of it. Disconnect the MES plug from its socket. Strip each end of the speaker wires. Then, insert one end of each wire into each plug opening. If you don’t have wires, you can use paperclips instead.

Why does my Honda Accord tail lights keep blowing out?

So you’ve changed the tail lights’ fuse in your Honda Accord, but it continues to blow out. The problem could be attributed to the fuse’s circuit or its amperage rating could be off, but don’t panic.

What to do if you have a blown fuse on your Honda Accord?

Check those fuses first, but check all the fuses before deciding that a blown fuse is not the cause. Replace any blown fuses and check if the device works.

How do you change the fuse on a Honda Accord tail light?

Inspect the wires of the tail lights’ circuit leading to and from the fuse in the fuse box. Cut the wire at the point of the short using a pair of wire cutters. Install a male connector to the end of one wire and a female connector to the other. Plug in the connectors. Install a replacement fuse.

Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice.

Why does my car not start after shorting out the SRS light?

To make a long story short my car wouldn’t start after shorting out the SRS light when you short the SRS it fries your main control module under the steering wheel which will cause your car to not start. Never Short out anything Electronic it will not fix the problem it will make the situation worse. Was this answer helpful?

Why does my Honda SRS light not reset?

The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.

When did the SRS light go out on my Honda Odyssey?

53-33 Internal Failure of SRS Unit. The SRS light originally came on about a year after I had purchased the Ody. I then cleared the codes and the SRS light went out. When I started the engine, the SRS light came back on and stayed on. I checked the codes again and it only output one. The 53-33 code.

What should I do if my SRS light keeps coming on?

If you don’t have wires, you can use paperclips instead. Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. Hold the stripped ends of both wires together again.

Why is my SRS light not working on my Honda Accord?

Tried the battery thing, the MES plug light reset and basically nothing works, Most cheap scanners including the Snapon Solus-Pro won’t read air bag .or abs codes.

Where is the SRS plug on a Honda Accord?

(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.

Where is the reset button on a Honda SRS light?

To do so, you will be “shorting” the system in order to reset the light. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.

Do you need to replace the SRS light?

the SRS deploys, the airbag module will not function again and must be replaced. As a reminder, the SRS indicator light will stay on continuously after deployment. Only an authorized Honda dealer should repair or replace the system. COMPONENTS of SRS AIRBAG ASSEMBLY KNEE BOLSTER RIGHT DASH SENSOR LEFT DASH SENSOR SRS CONTROL UNIT

What does the warning light on my Honda Accord mean?

Honda Dashboard Warning Light Symbols and Meanings (Accord, Civic, Crv, Fit ) 1 – A warning light that indicates that your front fog lamps are on. 2 – A warning light that indicates that your rear fog lamps are on. 3 – It is a warning light that indicates to the right or left.

Navigation