Can a Sportster have spark and still not start?

Can a Sportster have spark and still not start?

Not sure how you can have, both, spark & fuel and still no start. You absolutely have to be missing one of them. You need to go back and verify that the Sportster not getting spark. Are you getting fuel to your float bowl? If so, is the float height correct? Confirm that your needle valve is not hanging up. Verify that your gas cap is vented.

What to do if your Harley Davidson has no spark?

Just installed 12″ bars and cam plate. Buttoned it all up and tried to start it. Motor turns over fine, however no spark. Pulled the plug wires, put another plug in wire and no spark. Took tank back off, no pinched wires. Tested B terminal of coil plug and getting 12 + Volts. Removed power commander, hook bike back to ecm, no spark.

How to know if your engine has no spark?

First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.

What kind of car does not get spark?

Hello, I have a 2000 XLC 1200 with 30,000 miles she sat for about 5 years. when I fire her up, she starts fine and sounds good. I ride her for about 5 minutes and she dies, she still cranks, she has spark and she is getting fuel but will not start.

Why is my Harley Davidson Sportster not igniting?

One of the most common sources of electrical problems is the battery. Test the battery’s state of charge and current capacity by reading Step 2 of the article Electrical Diagnostic Guide. If no spark is present at the end of the spark plug wire, the air/fuel mixture cannot ignite.

How to check spark plugs on Harley Davidson Sportster?

Insert a spark tester into the wire and attach the tester to ground. Remove the fuel pump fuse. Refer to the article Fuse Box Information for fuse locations. Crank the engine and watch for spark. If spark is consistently present, the problem most likely lies with the spark plugs and you should continue to Step 2.

How does the ignition coil work on a Harley Davidson Sportster?

The ignition coil on later model Sportsters. The crankshaft position sensor is used to determine the crankshaft’s speed and position. The E.C.M. or ignition module uses this information to correctly time the spark at the spark plug with the piston.

Not sure how you can have, both, spark & fuel and still no start. You absolutely have to be missing one of them. You need to go back and verify that the Sportster not getting spark. Are you getting fuel to your float bowl? If so, is the float height correct? Confirm that your needle valve is not hanging up. Verify that your gas cap is vented.

What was the problem with my Harley Davidson?

After about 15 mins she showed up and said her bike would not stay running. At each stop, it would stall but would always start after the fact. It died in the driveway. We tried to troubleshoot the problem but have been unsuccessful so far. Checked the fuel pump, getting gas, changed the plugs and checked the wires for leaks, no leaks.

Why is my motor not working on my Sportster?

Check your speedo head for DTC’s. A failing crank position sensor can cause a problem like yours. A bad sensor will sometimes fail when heat is introduced and begin working again once it cools.

When did my Wife’s Harley start to misfire?

My wife’s 2005 FLHTCUSE2 began to develop problems a few weeks ago. After a short ride, we stopped for her to get gas. On the way home, her Harley started to misfire and run poorly. I lost sight of her so I pulled over. After about 15 mins she showed up and said her bike would not stay running.

Check your speedo head for DTC’s. A failing crank position sensor can cause a problem like yours. A bad sensor will sometimes fail when heat is introduced and begin working again once it cools.