How do I reset my GE Spacemaker washer?
To reset washing machines that use the GE Hydrowave system, start by unplugging the washer for one minute. Plug the washing machine back in and then within 30 seconds, quickly open and close the lid six times. You’ll need to do this within a 12-second period.
Why is my GE washer not spinning clothes dry?
When your washer will not spin dry your clothes, the debris filter or coin trap may be blocked. Your washer has a filtering device down and near the pump called a drain filter or a coin trap. The drain filter is accessed on the front bottom of the washer and the coin trap is located behind an access panel.
Why did my washer stop spinning?
An unbalanced load of laundry is one of the most common causes of an inadequate spin cycle. Sometimes clothing can settle on one side of the drum, throwing off the motion of the washing machine. If you suspect a distribution problem, try rearranging your clumped-up wet laundry and running the spin cycle again.
What is the problem if the washing machine wont spin?
Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
Why does my GE front load washer not spin?
The first thing to check when a GE front load washer won’t spin is the belt and pulley. Remove the back panel off the washer to access the belt and pulley. Check to see if the belt is worn or broken and if so, replace it. If this is the case the pulley will have to be replaced.
Why is my washer not spinning?
What would cause a washer not to drain or spin?
If the washer won’t drain or spin, either something is stuck in the washing machine drain hose or pump, or the pump is broken. If a washer won’t drain or spin, the fix is simple if you’re even just a little bit handy with tools.
Why is my washing machine not doing spin cycle?
How do you fix a washing machine that will not spin?
- Redistribute an off-balanced load of laundry.
- Level an off-kilter washer.
- Check the power source.
- Stop using an extension cord.
- Inspect the spin switch.
- Stick to high efficiency detergent with a front-load washer.
- Undo any kink in the hose.
- Track down a blockage in the drainage system.
What are some common problems with ge top load washers?
Water flow issues are among the more common problems in GE washing machines, and they are generally easy to fix. If your washer won’t fill, check the hot and cold faucets to make sure they’re both turned on fully. GE washers require water pressure between 10 and 120 pounds per square inch.
Why would a GE dryer stop working?
The most common causes for an electric or gas dryer to stop drying or heating is: 1. The dryer lint screen (lint trap) has not been cleaned (poor or restricted airflow). 2. A clogged or kinked (bent) dryer air vent hose (inadequate or no airflow).
Why does GE washer not spin?
If your GE front load washer won’t spin or tumble you may have a problem with the inverter or motor. If this is the case, you will see a motor or inverter error code. On these GE front load washer models these three errors are motor errors and can be caused by a bad inverter or motor.
How do you troubleshoot clothes dryer?
Start by checking the plunger located on the door for dryer troubleshooting. If it’s missing or bent, replace it. If the plunger checks out, the next step of dryer troubleshooting is to remove the top cabinet panel to gain access to the door switch. See the disassembly instructions.