How do you replace tail light bulb on Dodge Ram?
Pull out the plate and find the bulb you need to replace. Just pull the bulb out and insert the new one. You should hear it click into place. After that, it’s just the reverse process to install the assembly: Attach the bulb circuit plate to the tail light assembly and tighten the four Phillips screws.
How to change the turn signal on a Dodge Ram?
Refer to the inside sticker of the fuse box panel and locate the two flasher relays. Switch the relays, and check if the turn signal lights are flashing. If one or both of the relays fails to turn on the turn signal light, replace as needed.
Where is the brake light switch on a Dodge Ram?
Dodge Ram turn signal lever. The brake light switch can wear out, which translates into no brake lights on your Dodge Ram. If the bulbs as well as the connections are good and the wires are properly grounded, replace the switch. You will find it under the brake pedal. Figure 4. Brake light switch.
Where are the flasher relays on a Dodge Ram?
Refer to the inside sticker of the fuse box panel and locate the two flasher relays. Switch the relays, and check if the turn signal lights are flashing. If one or both of the relays fails to turn on the turn signal light, replace as needed. Figure 2. Flasher relay.
Pull out the plate and find the bulb you need to replace. Just pull the bulb out and insert the new one. You should hear it click into place. After that, it’s just the reverse process to install the assembly: Attach the bulb circuit plate to the tail light assembly and tighten the four Phillips screws.
How do you remove a tail light from a car?
Remove any clips or bolts that are securing the light to the vehicle. To remove these clips, use a pair of needle nose pliers and press down or pull up on the clip depending on the location of the attachment. Step 3: Remove the tail light from the vehicle.
Why are my tail lights not working properly?
Once the sun sets, our tail lights are used to alert drivers behind us of our presence on the road. However, one of the most frustrating situations a driver can face is when those lights don’t work as well as they should. Typically, these problems are related to condensation inside the light housing.
What to use to seal tail light gasket?
Most car owners will choose to use a waterproof caulking compound to seal the gasket. Others decide to take the headlight or tail light completely apart and replace the entire seal. The method for completing this step will vary based on the materials you use. However, if you’re using a waterproof silicone, the instructions are rather simple.