How long does it take to drain a new car battery?
New Car Batteries A new and fully car battery can stay for around two weeks without needing to be recharged from a generator. This battery will fully get discharged after approximately two to three months. If you leave the battery for roughly two and a half months, you will not be able to start the car engine.
How long does Polo car battery last?
How long does a VW Polo battery last? Volkswagen Polo car batteries have a decent lifespan, lasting up to six years. This, however, can vary depending on the region’s climate where the car is being used as well as your driving habits and vehicle maintenance.
Which battery is good for Polo car?
Exide Manufactures Best Suited Battery for Volkswagen Polo.
How can I Fix my VW Polo battery?
Watch for the ammeter to drop to acceptable drain. The fuse that reduces the drain is the draw. Consult the owners’ manual or service manual to find what circuits are on that fuse. 6. Check each device (circuit) on that fuse. Stop each lamp, heater, etc. to find the drain. 7. Repeat steps 1&2 to test your repair.
Why does the battery drain on my polo ice?
I’ve had a battery drain for the last few months, and its between 0.2-0.3 mA which is quite high, but when the F30 fuse is pulled the drain lowers to 0.04 mA which is the volkswagen standard, noticed when i put the fuse back in theres a clicking noise which I’m guessing just confirms that it is the fuse circuit that is causing the problem.
What to do when your VW Polo drains?
Go to the fuse panel (s) and remove fuses, one at a time. Pull the main fuses (higher amp ratings)last. 5. Watch for the ammeter to drop to acceptable drain. The fuse that reduces the drain is the draw. Consult the owners’ manual or service manual to find what circuits are on that fuse. 6. Check each device (circuit) on that fuse.
What’s the drain on a Volkswagen F5 battery?
I’ve had a battery deain for the last few months, and its between 0.2-0.3 mA which is quite high, but when the F5 fuse is pulled the drain lowers to 0.04 mA which is the volkswagen standard, noticed when i put the fuse back in theres a clicking noise which I’m guessing just confirms that it is the fuse that is causing the problem.