How much is a starter for a Yamaha Raptor?
Compare with similar items
| This item New Starter Replacement For Raptor 660 Yamaha 2001 2002 2003 2004 2005 3SX-81890-00-00 AP8520003 | Caltric Starter Compatible With Yamaha Raptor 660 Yfm660 660Cc 2001 2002 2003 2004-2006 | |
|---|---|---|
| Price | $5695 | $44.00$44.00 |
| Sold By | OEG Parts | Caltric |
What is a 2001 Yamaha Raptor worth?
Values
| Suggested List Price | Average Retail | |
|---|---|---|
| Base Price | $6,499 | $2,260 |
| Options (Change) | ||
| Total Price | $6,499 | $2,260 |
How fast is a 2001 Yamaha Raptor?
Top speed of both is limited electronically at 75 mph (but modifiable).
How many gears does a 2001 Yamaha Raptor have?
Yamaha sold the Raptor 660 from model year 2001 through 2005. The Raptor 660R was replaced in 2006 by the totally redesigned Raptor 700R (686cc)….Yamaha Raptor 660.
| Engine | |
|---|---|
| Carburation | Dual Mikuni 33mm BSR |
| Ignition | CDI |
| Starting system | Electric |
| Transmission | Five-speed manual clutch with reverse |
How much horsepower does a 2001 Yamaha Raptor 660r have?
The Yamaha Raptor 660 is a 398 pound sport class all-terrain vehicle(ATV) manufactured by Yamaha Motors Inc from 2001 to 2005. The 660 Raptor includes a 36 horsepower 660cc, five valve, 4-stroke liquid cooled engine with the most displacement available in any quad at the time.
How much is a 2006 Raptor worth?
Values
| Suggested List Price | Average Retail | |
|---|---|---|
| Base Price | $6,999 | $3,840 |
| Options (Add) | ||
| Total Price | $6,999 | $3,840 |
What is a 2006 Raptor 700R worth?
How to install starter clutch on Raptor 660?
1 Remove four bolts to the starter idler cover. Remove the small idler gear and set aside with the cover. 2 Remove the left case cover. Loosen the nine bolts in a criss-cross pattern so as to avoid warping the cover. Once all are loose, remove them.
What should the nut be on a Raptor 660?
Grab your strap wrench and place it on the flywheel and tighten the nut to 110 ft/lbs or 150 N/m. Once again, you may need a helper to hold the rear brake and the bike may need to be in gear. Make sure everything is well lubricated.
How big are the clutch bolts on a raptor?
Tighten the bolts in a criss-cross fashion to 11 ft/lbs or 16 N/m. This is critical, you must torque these bolts correctly and evenly!
Where is 52 tooth idler gear on Raptor 660?
Pull the 52 tooth (large gear behind the flywheel) idler gear off the shaft. If you have a 2001, remove the needle bearing and set aside. You will not reuse this bearing if you purchased a kit. The gear we sent to you is ready to go with a pressed in brass bushing. Check the bearing surface for wear and pitting and replace if worn.