What is the no start code for MaxxForce?
No start code spn 2012 durastar international maxxforce DT. No start code spn 51 fmi 11 comes active when cranking. Codes spn 2798 fmi 4 and 3 spn 2797 fmi 3and 4 … read more
What happens if SPN 132 FMI 11 MAF sensor fails?
If SPN 132 FMI 11 – MAF sensor calibration failed – Insufficient number of data points sets, engine conditions are not stable to accept MAF calibration 1. Check to ensure entry conditions were all met (if EOT or ECT become lower than 176 F, test will fail) 2.
What kind of FMI does Maxforce 13 have?
Maxforce with spn132 fmi4. 2010 international work star dt9. Auto Mechanics 1&2/diesel… Vocational, Technical or Tra… Vocational, Technical or Tra… I have a 2012 Internationañl Pro Star with a Maxxforce 13 In it. The thing surges sometimes especially at idle. I have got codes. SPN 354 FMI 4 … read more
Is the 2012 International 4300 MaxxForce engine running?
2012 IH 4300 1HTMMAAN9CH084057, Last week there was a code for Injector 3 close coil-open circuit, (SPN 3661 FMI 5) The truck ran fine, so we cleared the code and let it go. Today it’s barely running. … read more I have a 2014 international lone star with the maxxforce 13.
When did the International Maxxforce Engine come out?
International MaxxForce engines built in 2013 and after will already come with the fix. An International dealer can determine whether pre-2013 engines have been updated with the improved parts.
What should I do if my check engine light is still coming on?
Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step. Once it is done, see if the engine check light is still coming on or not. If the check light is off, you are ready to go, but if it is still coming on, get ready by reading the codes with a scanner instead. Let it Go Off Itself
What is the no start code on a DuraStar?
2012 durastar international maxxforce DT. No start code spn 51 fmi 11 comes active when cranking. Codes spn 2798 fmi 4 and 3 spn 2797 fmi 3and 4 … read more Vocational, Technical or Tra… I have 9 inactive codes on my 2012 internatiol 4300 durastar with maxxforce dt466e engine.
Can a MaxxForce DT diesel engine have no codes?
If a Maxxforce DT diesel engine in our fleet experiences low power with no codes we will be pursuing the same areas we looked at for this fix. As a matter of fact there is another bus in our fleet with similar problems. Experience has paid off once again.
Why does my MaxxForce DT have low power?
It’s also recommended to check the air filter for any restriction. This of course will cause more of a low pressure area in the intake system. If you’re working on the MaxxForce DT you must have the servicemaxx software. After this operation is completed a MAF recalibration is needed.