Where can I buy a flex fuel conversion kit?

Where can I buy a flex fuel conversion kit?

Select your preferred location and we’ll note which parts are ready to be picked up TODAY. Sold as a kit. (33) Select your preferred location and we’ll note which parts are ready to be picked up TODAY. Advanced Fuel Dynamics PFC-JSRT2-1 – Advanced Fuel Dynamics PROFLEX Commander Systems for Jeep Grand Cherokee SRT/SRT-8

What do you need for a fuel sending unit?

The fuel sending unit setup can vary from vehicle to vehicle, so the tools needed can range from a screwdriver to a set of ratchets and sockets to a drip pan to a gasket sealer. It’s a good idea to check with a manual to find out which tools you’ll need.

How much does a Mercedes Benz diesel engine weigh?

In its 143 kW variant, the first all-aluminium four-cylinder diesel engine from Mercedes-Benz weighs 168.4 kg, i.e. 35.4 kg (17 percent) less than its 125 kW predecessor – a new benchmark in its output class.

How to change the fuel in a fuel tank?

The next step requires a disconnection of the fuel filler hose and the fuel pump wiring harness. Then remove the fuel lines from the fuel sending unit. It’s a good idea to support the fuel tank with a sturdy object—like block of wood and a jack. Then take off the fuel tank straps that hold the tank in place.

How do you replace fuel gauge and sending unit?

Remove the screws that hold the sending unit to the tank and take it out. Next, remove the three wires on the back of the old gauge. One wire goes to the center pin on the tank sending unit, one goes to ground, and the third connects to a 12-volt source, normally the ignition switch.

Where are the fuel pipes in a Bosch metering unit?

Screw the fuel pipes you are going to use for testing purposes into the metering unit. Basically you can use the original pipes, but you will need to detach them from the nozzles first. Place the measuring glasses under the opposite ends of the fuel pipes.

Do you need to disassemble the fuel distributor?

Disassembling the fuel control unit (the fuel distributor). You need to be especially careful and cautious here. The fuel control unit as well as the fuel distributor is a very expensive spare part and it is becoming more and more difficult to find it on a stand of a specialized shop or a market with each upcoming month.

What to do if fuel leaks from metering unit?

Carefully lift the pressure disk of the air metering unit. After that the fuel should leak out of the fuel pipes you are using for testing purposes. Diagnosing the metering unit performance twice would be enough. Use different ladings and be sure to keep the pressure disk completely lifted for about 30 seconds.