Where does the vacuum hose go in a V8?

Where does the vacuum hose go in a V8?

Here is the vacuum diagram for your car (BELOW). The 3rd goes to the fuel tank, the smaller hose goes to the MAP sensor. There are not many lines. I was unsure to give you the answer because its V8 and there’s 2 different engines and the vacuum diagrams are different-I can provide the other diagram if you wish-hoping its the one you’re looking for.

What is the hose coming out of the top of the transmi?

Fluid is full. I noticed a small hose coming out of the transmission that goes straight up and curves over. It is not connected to anything at the other end. It was loose. It looks like it should clip into the side of the air filter box. I can’t see anything it should connect to. Is this correct? What is this hose for? My car has 20000 miles.

What do vacuum hoses look like on a car?

Learn more… Knowing what faulty vacuum hoses look like is an important part of keeping your car in good condition. Many of these hoses control your car’s idle, emissions components and environmental controls such as your heat. This article will tell you how to check engine vacuum hoses.

Can a regular vacuum line be used to replace an emissions hose?

Another thing to be aware of is that you cannot use regular vacuum hose to replace emission hoses. You must use emissions hose (or fuel line hose)on those hoses. Regular vacuum hoses just aren’t strong enough to work.

Where does the vacuum hose go in a car?

Detach the vacuum hose from a system or accessory of your car, such as the hose from your heater or cruise control. Attach your vacuum gauge and start your vehicle’s engine.

What happens if the vacuum hose is missing from the transmission?

The transmission will work without this line, but the shifts will be hard as if the throttle was all the way to the floor. If the hose is broken or missing, there will also be a vacuum leak at the carburetor, causing a rough/high idle and possible an intermittent backfire.

Where does the vacuum line go in a truck?

If the truck has a vacuum hose to the transmission (to the vacuum modulator), the line will be a metal tube attached to the large tube that the transmission dipstick is in. It will come up and connect to a hose that will run to the base of the carburetor.

What kind of pickup truck has a vacuum hose?

Repair guides and support for C/K pickup trucks sold by General Motors under the GMC brand, including the GMC Sierra. Answered! View the answer I have this problem too

Where can I find diagrams of vacuum hoses?

There doesn’t seem to be a comprehensive source for vacuum hose diagrams. Bentley, Haynes and others are sketchy, the parts fiche gif images are grainy and have too much detail and mainly verbal descriptions exist in the Type 2 archives and at Bus Boys. I’ve compiled this information from personal measurements, ETKA and other sources.

How do you get a vacuum diagram for free?

Vacuum Diagrams This is not an automated service. Each Diagram that is requested has to be hand selected and sent. As this is a free service it receives an overwhelming amount of requests and may take up to a week or longer for a response. Just submit a request for the Vacuum diagram you want.

There doesn’t seem to be a comprehensive source for vacuum hose diagrams. Bentley, Haynes and others are sketchy, the parts fiche gif images are grainy and have too much detail and mainly verbal descriptions exist in the Type 2 archives and at Bus Boys. I’ve compiled this information from personal measurements, ETKA and other sources.

How many hoses are in a Quadrajet vacuum line?

Oct 15, · I know what the stock diagrams show, Quadrajet Vacuum hose routing. I know what the stock diagrams show, That switch had like 5 hoses going to it. A ported vacuum source, a manifold vacuum source, a line going to some switch on the rear of the carb, a vacuum advance and some crazy vacuum retard.

Where is the vacuum line on a V8?

In these V8 diagrams, the vacuum line to the base of the carb on the manifold actually indicates ported vacuum, not manifold vacuum. Yes, it’s confusing. Also, in these diagrams “10-20-40” and “10-25-45” indicate FSJ’s, while “80” indicates a CJ.

Can a 4.6L V8 be used as a vacuum line?

Generally, this procedure should apply to all 1994, 1995, 1996, and 1997 T-Birds & Cougars with the 4.6L V8 engine. The process will be similar for 3.8L V6 and 5.0L V8 equipped cars, so refer to your underhood vacuum hose routing label for more details.