How do I reset ap9617 APC?
Press the Reset button. The Status LED will flash alternately orange and green. Press the Reset button a second time immediately while the LED is flashing to reset the user name and password to their defaults temporarily.
How do I restart APC UPS remotely?
Tutorial APC UPS – Restart the management interface only Open your browser and enter the IP address of the APC UPS. After a successful login, you will be sent to the APC UPS Dashboard. Select the Reboot Management Interface and click on the Apply button. In our example, the Network Management Interface will restart.
How do I reset my NMC APC password?
Press the Reset button a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc).
How do you hard reset a UPS?
The Brain Dead procedure performs a hard reset of the Smart-Ups microprocessor….Cold Start:
- Turn off and unplug the Smart-UPS from wall.
- Press and hold the power button (labeled “”I/TEST”” on legacy non-LCD screen units) on the front of the UPS until you hear a LONG beep.
- Let go DURING the long beep.
How do you reset UPS online?
Turn off and remove any equipment connected to the UPS. 2. Turn off the UPS: press and hold the On/Off button until the UPS beeps, then release the button. Disconnect the UPS from the AC outlet.
How do I configure APC Network Management Card network settings?
Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.
- Apply the port settings to establish the connection.
- Press enter 3-5 times to display the username prompt.
- Use the default username and password of “apc”.
How do you reset an APC 9617 card?
From the documentation for the AP9617 card, 5. Press the Reset button. The Status LED will flash alternately orange and green. Press the Reset button a second time immediately while the LED is flashing to reset the user name and password to their defaults temporarily. 6.
What are features of APC network management card AP9617?
The front-panel features of the Network Management Card (AP9617) include Status LEDs, a Reset button, and a 10/100Base-T connector. Resets the Management Card while power remains on. Connects the Management Card to the Ethernet network. See Link-RX/TX (10/100) LED.
How do I Reset my APC surge protector?
How do I reset my APC surge protector? Reset the circuit breaker on the battery backup. APC battery backups have a labeled circuit breaker button located on the unit near the phone line, fax line, USB, network and coaxial cable inputs. Press the button to reset the circuit breaker. Power on the battery backup by pressing the power button.
How do I Reset my APC battery backup?
Reset the circuit breaker on the battery backup. APC battery backups have a labeled circuit breaker button located on the unit near the phone line, fax line, USB, network and coaxial cable inputs. Press the button to reset the circuit breaker. Power on the battery backup by pressing the power button.