How do you check the oil on a 2008 Honda Accord?

How do you check the oil on a 2008 Honda Accord?

Turn the ignition to run (one position before starting engine). Press the SELECT/RESET button until the engine oil life indicator is displayed. Press the SELECT/RESET button for more than 10 seconds. The engine oil life indicator and the maintenance code(s) will blink.

Where is the oil supposed to be on a dipstick?

At the base of the dipstick, there are two marks or small holes indicating the high and low levels of engine oil. The oil level should be between these two marks. Both too high and too low are bad for the car.

How do you read the oil dipstick on a Honda Accord?

How to Read the Oil Dipstick in a Honda Accord. These mark the safety zone for the safe running of your engine. Slip the dipstick back into the sheath and pull it right out to get a clear reading. Look at the oil level on the dipstick without wiping it off. Check to make sure you are in the marking range with the dipstick pointing down.

How do you change the oil in a Honda Accord?

For most Hondas, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Honda Accord oil filter wrench. If your Accord is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Accord.

Can a check engine light be used on a Honda Accord?

If you do not have a check engine light on in association with the VVT solenoid then you can replace just the gaskets. No Honda Bond is used with these gaskets. Most of the time this fixes the problem. This has to be something wrong with the manufacturing of this model accord.

How to fix an oil leak on a Honda Odyssey?

So fix it as fast as possible or you will lose your alternator. There is a gasket under the spool assembly, you need to change that or smear hondabond around the edge of the assembly. Here is a video of the same thing on a Honda Odyssey which uses the same gasket. Click to expand… Would this same procedure work for a 2010 Honda Accord EX-L?

What causes oil build up in Honda Accord?

Conditions that can cause deposit buildup and lead to oil consumption include operating the engine while cold (not allowing it to warm up to a proper operating temperature); hard acceleration while the engine is cold; and using fuel with an unusually high concentration of particulate matter.

How to fix oil leak on Honda dipstick?

New rocker arm oil control assembly is $100+. Hondabond and Chinese gaskets may fix it for you. Good luck. There is a gasket under the spool assembly, you need to change that or smear hondabond around the edge of the assembly.

Is there an issue with my Honda Accord?

2008-2011 Honda Accord Oil Issue. CARS.COM — Vehicles affected by service bulletin: The problem: Under certain operating conditions, the engine in certain Accords may develop deposits on the piston’s oil control rings, which may lead to excessive oil consumption.

If you do not have a check engine light on in association with the VVT solenoid then you can replace just the gaskets. No Honda Bond is used with these gaskets. Most of the time this fixes the problem. This has to be something wrong with the manufacturing of this model accord.