How do you remove a pulley from a water pump?
If the vehicle has a v-belt, you can simply loosen the tensioner to relax the belt. Once the belt is loose enough, remove it from the pulleys. Note: To remove the pulley bolts, you may have to go under the vehicle or go through the fender near the wheel to access the bolts. Step 4: Remove the pulley from the water pump.
How can I tell if my water pump pulley is out of alignment?
Grab a flashlight and visually check the water pump pulley for any cracks and to see if it is out of alignment. Step 2: Start the engine and test the pulley. With the engine started, check whether the pulley is working correctly. Watch for any wobbling or note if it makes any noises as if the bolts are loose.
What causes a water pump pulley to wobble?
Cracks can also form on the pulley if the bolts come loose or the pulley has too much stress applied to it. Additionally, the pulley can bend if the belt is at an angle because of an accessory that is not aligned properly. This will cause the pulley to have a wobble effect.
If the vehicle has a v-belt, you can simply loosen the tensioner to relax the belt. Once the belt is loose enough, remove it from the pulleys. Note: To remove the pulley bolts, you may have to go under the vehicle or go through the fender near the wheel to access the bolts. Step 4: Remove the pulley from the water pump.
Grab a flashlight and visually check the water pump pulley for any cracks and to see if it is out of alignment. Step 2: Start the engine and test the pulley. With the engine started, check whether the pulley is working correctly. Watch for any wobbling or note if it makes any noises as if the bolts are loose.
Cracks can also form on the pulley if the bolts come loose or the pulley has too much stress applied to it. Additionally, the pulley can bend if the belt is at an angle because of an accessory that is not aligned properly. This will cause the pulley to have a wobble effect.
How to install a power steering pump pulley?
Install the Camshaft Pulley Installer, Water Pump Pulley Spacer and the Power Steering Pump Pulley Installer. A. Using the Camshaft Pulley Installer, Water Pump Pulley Spacer and the Power Steering Pump Pulley Installer, install the coolant pump pulley flush with the end of the camshaft.
What’s the best way to replace a water pump?
Use a ratchet or wrench to break loose the water pump pulley retaining bolts (do not remove the bolts at this time). If the pulley starts to spin, you can try putting some extra tension on the belt tensioner to hold it in place. Remove the drive belt by rotating the automatic tensioner.
How do you remove a water pump from a Saturn?
Pull the water pump and pulley away from the the mating surface of the engine and remove from the car. If you have to pry the water pump loose, use a gasket scraper and be careful not to damage the aluminum mating surface. When you remove the water pump, expect some coolant to come out.