How long is a 1991 Honda Civic hatchback?
157.1 in
Used 1991 Honda Civic DX Hatchback Specs & Features
| Dimensions | |
|---|---|
| Height | 52.5 in. |
| Length | 157.1 in. |
| Wheel base | 98.4 in. |
| Width | 66.3 in. |
How do you install a new radiator support?
Difficulty
- Remove any attached parts to gain access to the radiator support bracket bolts. Remove the radiator support bracket bolts.
- Remove the radiator support brackets.
- Install the new radiator support brackets. Check both sides to verify all parts that are attached are not damaged.
- Install the support bracket bolts.
What year is EF Civic?
Honda Civic (fourth generation)
| Honda Civic Fourth generation (EC/ED/EE/EF/EX) | |
|---|---|
| Manufacturer | Honda |
| Also called | Honda Ballade (South Africa) Honda Pro (JDM commercial van) |
| Production | September 1987–August 1991 September 1987–February 1996 (Civic Shuttle) |
How do you replace the radiator on a Honda Civic?
Be careful while applying torque load to the radiator support bolt. Before you lower the new radiator into place, attach the radiator fan shroud onto it (if applicable). Then, carefully lower radiator into place. Finally, bolt down the support bracket but don’t tighten it all the way. Figure 7. Attach fan shroud to radiator fan.
What should I do Before I Change my radiator?
Before you change a car radiator, let the engine cool, then take off the radiator cap. Drain the coolant, and flush the radiator if there’s rush in the cooling system. Once the radiator is drained, remove the hoses to the radiator and the reservoir.
How do you install an air conditioner in a Honda Civic?
Connect the receiver line B to the evaporator with one 6 x 25mm bolt. Route receiver line C under the wire harness. Connect the suction line B to the evaporator with one 6 x 25mm bolt. Push the radiator back, and mount the receiver lines to the pre-installed clips on the front wall of the engine bay.
Where is the overflow hose on a Honda Civic?
Once the cap is removed, grab the pliers, or flat head screwdriver, and loosen the clamp to remove the radiator overflow hose, then remove lower hose located on the bottom corner of the radiator. Figure 4. The overflow reservoir was located in that big empty space. Removing it will offer more flexibility. Figure 5. Remove lower radiator hose.
Be careful while applying torque load to the radiator support bolt. Before you lower the new radiator into place, attach the radiator fan shroud onto it (if applicable). Then, carefully lower radiator into place. Finally, bolt down the support bracket but don’t tighten it all the way. Figure 7. Attach fan shroud to radiator fan.
Where is the thermostat on a Honda Civic?
Locate the thermostat housing. You can do so by following the upper radiator hose to the engine block. Position your drain pan as best you can under the hose, so that it can catch any fluid when you disconnect it. Remove the radiator hose from the thermostat housing.
How to remove and replace a radiator support?
A 1996 Honda Accord was mainly used to demonstrate how to perform this task. Most radiator supports are welded in and have to be cut out and welded back in. If you are interested in learning more on how to do this type of repair and learn true body work and paint, follow this link: If you found this video valuable, give it a like.
Once the cap is removed, grab the pliers, or flat head screwdriver, and loosen the clamp to remove the radiator overflow hose, then remove lower hose located on the bottom corner of the radiator. Figure 4. The overflow reservoir was located in that big empty space. Removing it will offer more flexibility. Figure 5. Remove lower radiator hose.