How to get fault codes from eaton ultrashift?
To Retrieve Inactive Codes: Start with the key in the ON position. Turn the key OFF and ON four times within five seconds ending with the key in the ON position. After five seconds, the gear display begins flashing two-digit fault codes. If no codes are active, the gear display will flash code 25 (no codes).
How to read codes on eaton transmission?
Eaton Fuller Transmission Fault Codes
- Place the shift lever in neutral.
- Set the parking brake.
- Turn key on with engine off.
- To Retrieve Active Codes: Key on.
- To Retrieve Inactive Codes: Turn key on.
- Observe the sequence of flashes on the service light and record the codes.
How do you reset the transmission fluid light on a 2013 Chevy Captiva?
The Chevy Captiva ‘change transmission fluid’ warning will come up on the car’s dashboard when a fluid change is required. You can reset this by turning the key in the ignition over to the ‘on’ position and simultaneously press the gas pedal three times. Now, put the car off and start it fully.
How to check fault codes on Freightliner Cascadia?
Hold the button until the display shows “faults”. From there it will show you the number of active faults in the system. Again using the black button cycle through the “faults” to observe the SPN and FMI. All this means is there an active fault in each of those modules. Doesn’t tell you the actual fault code.
Where can I find the Mercedes Fault codes?
Mercedes MBE codes Page 13 Cummins ISB, ISC codes Page 27 Caterpillar 3126, C7 codes Page 31 EPA 2010 Products: J1939 Fault Codes Retrieving J1939 fault codes HDX/EFX Page 36 Retrieving J1939 fault codes C2 Page 39 Cummins codes Page 41 Allison Trans 2000 codes Page 81
Where can I find the fault code on my ICU?
Locate the LCD display in the center of the dash and the reset/mode button to the right Your ICU dash will display the MID numbers for the modules that have an active fault. The complete SAE formatted fault code can be retrieved via the dash. example: MID, PID or SID, FMI
Where can I find the J1939 fault code?
Retrieving J1939 fault codes C2 Page 39 Cummins codes Page 41 Allison Trans 2000 codes Page 81 Allison Trans 3000 codes Page 84 C2 BHM codes Page 90 Locate the LCD display in the center of the dash and the reset/mode button to the right